Results 101 to 110 of about 11,923 (234)
Technical Model of Micro Electrical Discharge Machining (EDM) Milling Suitable for Bottom Grooved Micromixer Design Optimization. [PDF]
Micromachines (Basel), 2020 Sabotin I, Tristo G, Valentinčič J.
europepmc +1 more source
The fabrication of beryllium. Volume III - Metal removal techniques [PDF]
Metal removal techniques for beryllium in spacecraft structure ...
Ingels, S. E., Williams, R. F.
core +1 more source
Effect of surface finishing on tribological properties of ZrO2-based composites [PDF]
, 2010 Laboratory-made ZrO2-based composites with 40 vol. % WC, TiCN or TiN were tested in dry sliding contact with WC-6wt%Co cemented carbide using an ASTM G133 pin-on-flat configuration.
Bonny, Koenraad +5 more
core
Effect of Graphite Electrode to Surface’s Characteristic of EDM
MATEC Web of Conferences, 2016 Electrical discharge machining process (EDM) is a process for removing material by the thermal of electrical discharge. Some of the melted and all of the evaporated material is then quenched and flushed away by dielectric liquid and the remaining melt ...
Muttamara Apiwat +3 more
doaj +1 more source
Wire electric-discharge machining and other fabrication techniques [PDF]
, 1983 Wire electric discharge machining and extrude honing were used to fabricate a two dimensional wing for cryogenic wind tunnel testing. Electric-discharge cutting is done with a moving wire electrode.
Morgan, W. H.
core +1 more source
Jurnal Energi Dan Manufaktur, 2015 Baru-baru ini, kemudahan permesinan benda kerja menggunakan proses ElectricalDischarge Machine (EDM) telah ditentukan oleh teori ?·?·?. Berdasarkan teori ?·?·?kemudahan proses EDM ditentukan oleh konduktivitas termal (?), temperatur titik leleh (?),dan ...
Nidia Lestari, Muslim Mahardika
doaj
On-machine wire electrical discharge dressing (WEDD) of metal-bonded grinding wheels [PDF]
, 2018 Metal-bonded diamond wheels, due to its strong grain retention and thermal conductivity properties, are generally used for grinding difficult-to-cut materials, such as high-performance ceramics.
Jaumann, Sascha +3 more
core
Environmental constituents of EDM [PDF]
, 2004 Thesis (S.B.)--Massachusetts Institute of Technology, Dept. of Mechanical Engineering, 2004.Includes bibliographical references (leaves 30-31).Electrical Discharge Machining (EDM) is a non-traditional process that uses no mechanical forces to machine ...
Cho, Margaret H. (Margaret Hyunjoo), 1982-
core
Sample preparation of metal alloys by electric discharge machining [PDF]
Electric discharge machining was investigated as a noncontaminating method of comminuting alloys for subsequent chemical analysis. Particulate dispersions in water were produced from bulk alloys at a rate of about 5 mg/min by using a commercially ...
Chapman, G. B., II, Gordon, W. A.
core +1 more source
Study and analysis of residual stresses in electro-discharge machining(EDM) [PDF]
, 2007 Technological advances have led to an increasing use of high strength, high hardness materials in manufacturing industries. In machining of these materials, traditional manufacturing processes are increasingly being replaced by more advanced techniques ...
Gholley, Raju, Soni, Pankaj Kumar
core