International Journal of Lightweight Materials and ManufactureElectrical Discharge Machining (EDM) has experienced significant advancements in modeling, optimization, and sustainability, reflecting the growing demand for intelligent and environmentally friendly manufacturing practices. Advanced modeling techniques,
Muhamad Taufik Ulhakim +6 more
doaj +1 more source
A Simulation Study of Debris Removal Process in Ultrasonic Vibration Assisted Electrical Discharge Machining (EDM) of Deep Holes †. [PDF]
Micromachines (Basel), 2018 Liu Y +5 more
europepmc +1 more source
Simulation of Electrical Discharge Machine (EDM) Process Pulse Generator Profile
International Journal of Science and Management Studies (IJSMS), 2019 Micro Electrical Discharge Machine (EDM) process efficiency is relatively related to the pulse generator, which is the process input. The paper focused on studying the performance of the pulse generator profile of EDM process by carrying out computer simulation in MATLAB/SIMULINK environment. A circuit is obtained for a pulse generator and mathematical
openaire +1 more source
Effect of surface finishing on tribological properties of ZrO2-based composites [PDF]
, 2010 Laboratory-made ZrO2-based composites with 40 vol. % WC, TiCN or TiN were tested in dry sliding contact with WC-6wt%Co cemented carbide using an ASTM G133 pin-on-flat configuration.
Bonny, Koenraad +5 more
core
Nonconventional Technologies Review, 2016 In the first part of this article the authors make a short presentation of the resistive current limitations technique used in Controlled Pulses Generators for die Sinker Electrical Discharge Machining.
Emanoil Toma, Carmen Simion
doaj
Effect of wire breakage on the process energy utilisation of EDM [PDF]
, 2016 DeSilva, Anjali K M +1 more
core +1 more source
GRA Coupled with Fuzzy Linguistic Reasoning for Quality Productivity Improvement in Electrical Discharge Machining (EDM) [PDF]
, 2012 In the present work, the use of the grey relational analysis and fuzzy logic combined with Taguchi method has been proposed for optimizing Electrical Discharge Machining (EDM) process with multiple responses involved.
Agarwal, Deepak Kumar
core
Influence of Speed of the Working Surface Cutting Discs during on EDM Cutting Ability Tool
Механика машин, механизмов и материалов, 2016 The article is devoted to the experimental study of the feasibility of restoring the cutting ability of the cutting disc by electrical discharge machining its surface directly in the performance of sawing operation.
Mikhail G. Kiselev +3 more
doaj
Effect of hole geometry and Electric-Discharge Machining (EDM) on airflow rates through small diameter holes in turbine blade material [PDF]
The effects of two design parameters, electrode diameter and hole angle, and two machine parameters, electrode current and current-on time, on air flow rates through small-diameter (0.257 to 0.462 mm) electric-discharge-machined holes were measured.
Cochran, R. P., Hippensteele, S. A.
core +2 more sources
Study of orifice fabrication technologies for the liquid droplet radiator [PDF]
Eleven orifice fabrication technologies potentially applicable for a liquid droplet radiator are discussed. The evaluation is focused on technologies capable of yielding 25-150 microns diameter orifices with trajectory accuracies below 5 milliradians ...
Bush, J. Michael +2 more
core +1 more source