Results 31 to 40 of about 11,865 (214)
Field Induced Jet Micro-EDM [PDF]
, 2013 Electrical discharge machining (EDM) is of the potential of micro/nano meter scale machining capability. However, electrode wear in micro-EDM significantly deteriorates the machining accuracy, thus, it needs to be compensated in process.
Kang, Xiaoming +2 more
core +1 more source
Transforming Grain‐Boundary Brittle Precipitates to Ductility Pathways in Complex Concentrated Alloy
Advanced Science, EarlyView.By engineering graded BCC/L12 interfaces, brittle precipitates in a complex concentrated alloy enable sequential deformation, realizing gigapascal strength with >20% elongation to solve the strength‐ductility trade‐off. ABSTRACT Conventional wisdom holds that hard grain‐boundary (GB) precipitates embrittle structural alloys by acting as crack ...
Zhixin Li +14 more
wiley +1 more source
Management Systems in Production EngineeringOne of the applications of electrical discharge machining nowadays, mainly nano powder mix electrical discharge machining, is to produce high-quality surface integrity materials. To achieve good results, change the input process settings as needed.
Sachit Qasim Abdulameer +1 more
doaj +1 more source
Enhancing Wire-EDM Performance with Zinc-Coated Brass Wire Electrode and Ultrasonic Vibration
Micromachines, 2023 This study aimed to investigate the performance of zinc-coated brass wire in wire-cut electrical discharge machining (EDM) using an ultrasonic-assisted wire on tungsten carbide.
Apiwat Muttamara, Patittar Nakwong
doaj +1 more source
Traveling wire electrode increases productivity of Electrical Discharge Machining /EDM/ equipment [PDF]
, 1967 Traveling wire electrode on electrical discharge machining /EDM/ equipment reduces the time requirements for precision cutting. This device enables cutting with a minimum of lost material and without inducing stress beyond that inherent in the material ...
Kotora, J., Jr., Smith, S. V.
core +1 more source
Materials and Corrosion, EarlyView.Ta‐Mo‐Cr‐Ti‐Al refractory high‐entropy alloys show atmosphere‐dependent oxidation performance based on Cr:Ti ratios. Cr‐rich compositions excel in dry oxygen through continuous chromia formation, while Ti‐rich alloys perform better in humid conditions due to reduced chromium volatilization and hydrogen uptake effects.
Fabian Lanoy +6 more
wiley +1 more source
SOFTWARE SIMULATION OF PRODUCTIVITY CHARACTERISTICS FOR EDM PROCESS
Nonconventional Technologies Review, 2022 The objective of the article is to briefly detail the main aspects that can influence the productvity of a micro-EDM and 3D printing processes for processing an alloy of TiAl6V4.
Nicolae Adrian Voinea +1 more
doaj
Engineering and Applied Science Research, 2018 This paper reports on the surface characteristics of a functionally graded Titanium (Ti-6Al-4V) alloy during Electrical Discharge Machining (EDM). The electrical discharge input parameters employed for this work are current (I), on-time (Ton), off-time ...
Sulaiman Abdulkareem +2 more
doaj +1 more source
Electrical measurements in µ-EDM [PDF]
, 2008 The phenomena occurring between the electrodes in electric discharge machining when manufacturing features on the micro-metre scale (µ-EDM) is not fully understood.
Ferri, Carlo +2 more
core +1 more source
Materials and Corrosion, EarlyView.Molten fluoride salt‐cooled reactors are being considered as the next generation nuclear reactors because they provide a number of benefits over current light water reactors, including enhanced safety. This work aims to develop an understanding of corrosion of structural alloys in molten fluoride salts for successful implementation of these reactors ...
Ryan Gordon +8 more
wiley +1 more source