Results 61 to 70 of about 1,046,815 (302)
Electrochemistry Communications, 2021 The frequency-dependent impedance of a metal/oxide/room temperature ionic liquid (RTIL) interface was separated into oxide layer (Cox) and double layer (Cdl) capacitances using electrochemical impedance spectroscopy (EIS).
Junsoo Han +4 more
doaj +1 more source
Electrochemical CO₂ Reduction to CO Catalyzed by 2D Nanostructures [PDF]
, 2020 Electrochemical CO₂ reduction towards value-added chemical feedstocks has been extensively studied in recent years to resolve the energy and environmental problems.
Erkey, Can +5 more
core
Transitions to Electrochemical Turbulence [PDF]
Physical Review Letters, 2005 We report experimental evidence of transitions from limit cycle oscillations through a phase turbulent regime to space-time defect turbulence in a spatially (quasi-)one-dimensional electrochemical system with nonlocal coupling. The transitions are characterized in terms of the defect density, the Karhunen-Loève decomposition dimension, and a measure of
Varela, H. +3 more
openaire +4 more sources
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
Advanced Engineering Materials, EarlyView.We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
Corrosion behaviour of brazing material AA4343 [PDF]
, 2006 This paper is part of a work devoted to corrosion of brazed AA4343/AA3003/AA4343 materials on water side of automotive heater cores. The microstructure of the superficial resolidified AA4343 brazing material has been previously characterised [1] and [2].
Blanc, Christine +5 more
core +4 more sources
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
The influence of anomalous codeposition on few coating alloys properties
Journal of Materials Research and Technology, 2019 Due to the presence of tungsten, Fe-W alloys can be applied as anticorrosive coatings. However, the conditions in which they are obtained influence their polarization resistance.
Mariana Borges Porto +4 more
doaj +1 more source
Destructive Impact of Molecular Noise on Nanoscale Electrochemical Oscillators
, 2017 We study the loss of coherence of electrochemical oscillations on meso- and nanosized electrodes with numeric simulations of the electrochemical master equation for a prototypical electrochemical oscillator, the hydrogen peroxide reduction on Pt ...
Cosi, Filippo G., Krischer, Katharina
core +1 more source
Electrochemical DNA sensors [PDF]
Nature Biotechnology, 2003 AbstractFor Abstract see ChemInform Abstract in Full Text.
Drummond, T. Gregory +2 more
openaire +3 more sources
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source