Results 41 to 50 of about 707,090 (200)
The Parameterisation of Electrochemical Machining [PDF]
ECS Meeting Abstracts, 2006 Abstract not Available.
Rachel Muir, Andrew Mount
openaire +1 more source
Effect of Cathode Feed Mode on Electrochemical Machining of Diamond Hole
International Journal of Electrochemical Science, 2019 Diamond holes are typically produced with small corner radii and high surface quality. Depending on the characteristics of the diamond structure, the influence of the tool-cathode feed mode on the diamond hole formation can be calculated by a numerical ...
Yafeng He +5 more
doaj +1 more source
Micromachines, 2019 As one of the most promising micro-machining methods, electrochemical micro-machining is widely used in the field of metal micro-structures. The electrochemical micro-milling on Nickel-base superalloy by using high-speed spiral electrode was studied in ...
Yong Liu +3 more
doaj +1 more source
Generation of complex surfaces by superimposed multi-dimensional motion in electrochemical machining
, 2022 384389In electrochemical machining the shape of the machined surface corresponds to the shape of the cathode and the applied electrical charge. In order to increase the flexibility of electrochemical machining for the generation of complicated surfaces ...
Kuhn, Danny +7 more
core +1 more source
Micromachines, 2019 To realize the electrochemical etching of a micro spiral cylindrical electrode, a new method of rotating electrochemical etching is proposed, and its process is further studied.
Qiuju Xiong +5 more
doaj +1 more source
Numerical simulation and experimental study on electrochemical milling of cemented carbide
Advances in Mechanical Engineering, 2023 In response to the difficulties in machining cemented carbide, this paper proposes a new approach to electrochemical milling of cemented carbide. A composite rotating tool cathode for electrochemical milling is designed, and the electric field simulation
Yafeng He +4 more
doaj +1 more source
Degradation modes and tool wear mechanisms in finish and rough machining of Ti17 Titanium alloy under high-pressure water jet assistance [PDF]
, 2013 This article presents the results of an experimental study on the Ti17 titanium alloy, which was carried out to analyze tool wear and the degradation mechanisms of an uncoated tungsten carbide tool insert. Two machining conditions, roughing and finishing,
GERMAIN, Guénaël +3 more
core +1 more source
International Symposium on ElectroChemical Machining Technology, INSECT 2009. Proceedings
, 2010 The International Symposium on ElectroChemical Machining Technology INSECT has established as a platform for well-chosen topics in ECM technology. In 2009, researchers and engineers are engaged in fundamental investigations of the electrode/electrolyte ...
core +1 more source
Micromachines, 2020 Wire electrochemical micromachining (WECMM) technology is regarded a promising method to fabricate high aspect ratio microstructures on hard-to-machining materials, however, the by-product accumulation in the machining gap limits its application. In this
Siying Ling +4 more
doaj +1 more source
Electrochemical Micromachining of Square Holes in Stainless Steel in H2SO4
International Journal of Electrochemical Science, 2019 A method for fabricating micro square holes with small corner radius is proposed, which could find applications in the aerospace and aviation industries.
Gu Mingcheng +2 more
doaj +1 more source