Results 41 to 50 of about 1,987,184 (244)

Study on Vibration Characteristics of Functionally Graded Material Composite Spherical Piezoelectric Transducer

open access: yesSensors
Non-uniform composite structures for transducers exhibit considerable potential in enhancing impedance matching and efficiency. Here, a functionally graded material composite spherical piezoelectric transducer (FGM-cSPT) is proposed, and a three-port ...
Sha Wang, Junjie Shan
doaj   +1 more source

Sensor-less parameter estimation of electromagnetic actuator for shunt damping

open access: yesNihon Kikai Gakkai ronbunshu, 2015
Electromagnetic shunt damping is a sensor-less passive damping technique using an electromagnetic actuator. The accurate values of the parameters of the system are essentially required for designing a controller in the damping technique.
Toru IKEGAME   +3 more
doaj   +1 more source

Repeated exercise stress impairs volitional but not magnetically evoked electromechanical delay of the knee flexors [PDF]

open access: yes, 2012
The effects of serial episodes of fatigue and recovery on volitional and magnetically evoked neuromuscular performance of the knee flexors were assessed in twenty female soccer players during: (i) an intervention comprising 4x35s maximal static exercise;
Bailey, A   +14 more
core   +1 more source

Sub‐Nanometer Curvature Unlocks Quantum Orbital Flexoelectricity in Graphene

open access: yesAdvanced Materials, EarlyView.
In self‐assembled, reproducible, large‐area, quasi‐pristine graphene nanowrinkles, extreme curvature forces out‐of‐plane π‐electrons toward hybridization, driving a transition from classical to quantum orbital flexoelectricity. As curvature approaches the fundamental physical limit set by the C─C bond length, the resulting polarization increases by ...
Sathvik Ajay Iyengar   +8 more
wiley   +1 more source

A Study of the Properties of a Piezoelectric Ceramic Plate in the Symmetric Fixation Mode

open access: yesIEEE Access, 2018
Piezoelectric power generation is commonly used to power wireless sensor nodes in vibration environments. A common piezoelectric power generation device is the piezoelectric ceramic plate (PCP), which is often fixed in the form of a cantilever beam ...
Benliang Hao   +4 more
doaj   +1 more source

Above Room Temperature Ferroelectricity in Epitaxially Strained KTaO3

open access: yesAdvanced Materials, EarlyView.
Through precise epitaxial engineering, the cubic and paraelectric KTaO3${\rm KTaO}_3$ is transformed into a robust ferroelectric. By leveraging lattice‐mismatched substrates to apply controlled epitaxial strain, a stable ferroelectric ground‐state is achieved with a transition temperature as high as 475 K, establishing KTaO3${\rm KTaO}_3$ as a highly ...
Tobias Schwaigert   +11 more
wiley   +1 more source

Design and analysis of innovative multi-frequency ultrasonic probe characteristics

open access: yesScientific Reports
This study presents the development of a novel multifrequency ultrasound probe distinguished by its broad bandwidth and high sensitivity. A comprehensive investigation was conducted using theoretical analysis, numerical simulations, and experimental ...
Yu-Lin Song   +3 more
doaj   +1 more source

Effect of Filling Material Properties on 1-3 Piezoelectric Composite Performance

open access: yesMicromachines
The 1-3 piezoelectric composite is the key component of the acoustic transducer, which is widely used in detection, due to the high energy conversion efficiency, cheap raw material, and low aging. To reveal the influence of epoxy mixture, used to connect
Yao Liu   +3 more
doaj   +1 more source

Direct Growth of 2D Bilayers on Au(111) for Low‐Coercive Sliding Ferroelectricity

open access: yesAdvanced Materials, EarlyView.
Controlled CVD growth of stacking‐defined bilayer ReS2 on Au(111) enables parallel‐stacked bilayers with intrinsic sliding ferroelectricity, a strong piezoelectric response, and an ultralow coercive voltage. Atomic‐resolution imaging and in situ measurements further reveal the decisive role of clean interfaces in achieving low‐barrier ferroelectric ...
Honglin Chen   +7 more
wiley   +1 more source

Polar Wurtzite NbAlN: A Transition‐Metal Nitride Alloy for Polarization‐Engineered GaN Heterostructures

open access: yesAdvanced Materials, EarlyView.
A novel polar wurtzite alloy, NbAlN, is demonstrated as a transition‐metal‐containing polar barrier for GaN heterostructures. Nb atoms form coherent nanoscale enrichment within the wurtzite lattice without disrupting metal polarity. This study demonstrates that transition metals can be integrated into polar nitrides to enable polarization‐related ...
Atsushi Kobayashi   +12 more
wiley   +1 more source

Home - About - Disclaimer - Privacy