Results 41 to 50 of about 28,947 (291)
Electro-optomechanical equivalent circuits for quantum transduction
, 2018 Using the techniques of optomechanics, a high-$Q$ mechanical oscillator may serve as a link between electromagnetic modes of vastly different frequencies. This approach has successfully been exploited for the frequency conversion of classical signals and
Schliesser, Albert +3 more
core +1 more source
Balanced electronic detection of displacement in nanoelectromechanical systems [PDF]
, 2002 We describe a broadband radio frequency balanced bridge technique for electronic detection of displacement in nanoelectromechanical systems (NEMS).
Ekinci, K. L. +3 more
core +1 more source
Piezoelectric Sensor-Embedded Smart Rock for Damage Monitoring in a Prestressed Anchorage Zone
Sensors, 2021 In this paper, a piezoelectric sensor-embedded smart rock is proposed for the electromechanical impedance monitoring of internal concrete damage in a prestressed anchorage zone.
Quang-Quang Pham +2 more
doaj +1 more source
Damage location method for thin composites structures - application to an aircraft door [PDF]
, 2013 Piezoelectric sensors are widely used for Structure Health Monitoring (SHM) technique due to their high-frequency capability. In particular, electromechanical impedance (EMI) techniques give simple and low cost solutions for detecting damage in composite
Cherrier, Olivier +3 more
core
Repeated exercise stress impairs volitional but not magnetically evoked electromechanical delay of the knee flexors [PDF]
, 2012 The effects of serial episodes of fatigue and recovery on volitional and magnetically evoked neuromuscular performance of the knee flexors were assessed in twenty female soccer players during: (i) an intervention comprising 4x35s maximal static exercise;
Bailey, A +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Applied Sciences, 2018 (Bi0.5Na0.5)0.94Ba0.06TiO3 dense ceramics were obtained from autocombustion sol-gel synthesized nanopowders and sintered at 1050 °C for 1–2 h for the study of the electromechanical anisotropy. Measurement of the complex impedance spectrum was carried out
Nicolás Pérez +3 more
doaj +1 more source
Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites
Advanced Engineering Materials, EarlyView.Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter +9 more
wiley +1 more source
Sensors, 2019 Ultrasonic transducer is a piezoelectric actuator that converts AC electrical energy into ultrasonic mechanical vibration to accelerate the material removal rate of workpiece in rotary ultrasonic machining (RUM).
Jian-Guo Zhang +4 more
doaj +1 more source
Crosstalk of cardiomyocytes and fibroblasts in co-cultures [PDF]
Open Biology, 2015 Electromechanical function of cardiac muscle depends critically on the crosstalk of myocytes with non-myocytes. Upon cardiac fibrosis, fibroblasts translocate into infarcted necrotic tissue and alter their communication capabilities.
J. Rother +8 more
doaj +1 more source