Results 191 to 200 of about 4,274,938 (365)

Formation of Intermetallic Sludge Phases in AlMgSi Alloys with High Concentrations of Alloying Elements: A Drawback for Increasing Sustainability

open access: yesAdvanced Engineering Materials, EarlyView.
Sludge phases with brittle fracture behavior form in AlMgSi alloys with high concentrations of alloying elements and negatively influence their ductility. The phase type mainly depends on the Si content and the concentration of minor alloying elements like Fe, Mn, Cr, and Mo strongly influences the number of sludge particles. The need for sustainable
Dominik Steinacker   +3 more
wiley   +1 more source

Improved Strength and Corrosion Resistance of Ti–50Zr Alloy Through Heat Treatment

open access: yesAdvanced Engineering Materials, EarlyView.
This work systematically analyzes the effects of heat treatment on mechanical properties and corrosion behavior of Ti‐50Zr alloy produced via vacuum arc melting. Microstructure transforms from coarse lamellar α phase in as‐cast condition to fine and uniformly distributes acicular α′ phase in heat‐treatment state.
Yuhua Li   +7 more
wiley   +1 more source

Electron Diffraction by Films of Grease [PDF]

open access: bronze, 1933
George Paget Thomson, C. A. Murison
openalex   +1 more source

Efficient and Scalable Radiative Cooling for Photovoltaics Using Solution‐Processable and Solar‐Transparent Mesoporous Nanoparticles

open access: yesAdvanced Functional Materials, EarlyView.
Graded refractive index (GRI) structures are prepared from the layer‐by‐layer spray coating of the mesoporous SiO2 nanoparticles, showing high solar transparency and thermal emissivity. Under outdoor conditions, after 50 days, the GRI‐coated photovoltaics show on average 6.65 ± 1.48 °C lower than that of the non‐coated references, maintaining 80.9 ± 8 ...
Heesuk Jung   +14 more
wiley   +1 more source

Experimental determination of partial charges with electron diffraction. [PDF]

open access: yesNature
Mahmoudi S   +11 more
europepmc   +1 more source

Stabilized Intermediate Phase Via Pseudo‐Halide Anions Toward Highly Efficient and Light‐Soaking Stable Perovskite Solar Cells

open access: yesAdvanced Functional Materials, Volume 35, Issue 12, March 18, 2025.
The formate pseudo‐halide anion is strategically introduced at the buried interface to stabilize the intermediate phases formed during perovskite crystallization. The controlled crystallization enhances crystallinity and alleviates tensile strain, eliminating residual PbI2 near the buried interface.
Jongdeuk Seo   +12 more
wiley   +1 more source

Home - About - Disclaimer - Privacy