Results 151 to 160 of about 1,228,090 (277)

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen   +4 more
wiley   +1 more source

High‐Temperature Oxidation of the CrFeNi Medium‐Entropy Alloy

open access: yesAdvanced Engineering Materials, EarlyView.
The oxidation behavior of equiatomic CrFeNi MEA is a key issue that determines this material's suitability for high‐temperature application. The understanding of long‐term behavior is even more crucial than short‐term corrosion effects. The alloy is exposed to synthetic air at 1000, 1050, and 1100 °C for 24, 100, and 1000 h and systematically compared ...
Anna Maria Manzoni   +5 more
wiley   +1 more source

Residual Stress States in Microstructurally Graded PBF–LB/M Austenitic Steel Components

open access: yesAdvanced Engineering Materials, EarlyView.
This study examines microstructurally graded 316L rectangular tube profiles fabricated via PBF–LB/M using a dual‐laser system. A 1 kW top‐hat and a 400 W Gaussian laser create distinct grain sizes and crystallographic texture. Mechanical properties are linked to microstructural evolution driven by processing conditions.
Nico Möller   +5 more
wiley   +1 more source

CALPHAD‐Guided Prediction and Interpretation of Phase Formation in Ta–Mo–Cr–Ti–Al Refractory High‐Entropy Alloys

open access: yesAdvanced Engineering Materials, EarlyView.
This study designs Ta–Mo–Cr–Ti–Al refractory high‐entropy alloys with a disordered body‐centered‐cubic A2 crystal structure aiming for improved ductility, lower density, and oxidation resistance. Four alloy compositions are identified by thermodynamic calculations.
Kateryna Khanchych   +7 more
wiley   +1 more source

Dysfunctional Electron Transport Chain Assembly in COXPD8. [PDF]

open access: yesJ Cardiovasc Dev Dis
Beutner G   +4 more
europepmc   +1 more source

Influence of Heat Treatment on Microstructure and Mechanical Properties at Elevated Temperatures of Nonweldable Ni‐Based Alloy Printed by Fused Filament Fabrication

open access: yesAdvanced Engineering Materials, EarlyView.
The fused filament‐fabricated MAR‐M247 alloy without hot isostatic pressing shows the lowest porosity of 4%. Heat treatment at 1220 °C produces coarse precipitates and carbides. Specimens heat‐treated at 1220 °C exhibit higher tensile strength (683 MPa) and elongation (10%) at room temperature.
Haneen Daoud   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy