Results 21 to 30 of about 2,548,254 (338)
Secondary discharge - a potential risk during system level ESD testing
, 2022 S.99-105By means of a floating handheld electronic product this work describes the influence of secondary discharge events during system level ESD testing on the failure threshold of the involved electronic circuit. In order to increase the robustness it
Gieser, H., Wolf, H.
core +1 more source
Shielding Study of Electrostatic Discharge
Sakarya Üniversitesi Fen Bilimleri Enstitüsü Dergisi, 2000 The electric and magnetic fıelds radiated by an ESD event are cal cu lated theoretically by using the di po le model. Experiments are perfonned and the ESD currents are measured for different discharge voltage.
S. SELİM ŞEKER +3 more
doaj +1 more source
Multiple current filaments and filament confinement in silicon based PIN diodes
, 2021 Electrostatic discharge (ESD) is one of the greatest reliability risks for modern electronics. Failures occur due to a high current injection. One of the dominant failure mechanisms during an ESD event is thermal runaway caused by an avalanche breakdown ...
Scharf, Patrick, Sohrmann, Christoph
core +1 more source
Electrostatic discharge protection of MiniLED backlight units on glass
Energy Reports, 2021 Active matrix (AM) MiniLED backlight units (BLU) on glass substrate is developed to solve severe problems of MiniLED on PCB including insufficient heat dissipation and worse swelling and shrinking performance, as well as limited zone number. However, the
Juncheng Xiao +8 more
doaj +1 more source
Sensitivity to ignition by electrostatic discharge of explosive dust / air [PDF]
MATEC Web of Conferences, 2019 In industrial sectors that use, process, transport or store, substances such as combustible dusts could exist some workplaces with explosion hazard due to the possibility of dust/air explosive formation and ignition, both inside the installations and in ...
Gabor Dan +5 more
doaj +1 more source
Electrostatic wear monitoring of rolling element bearings [PDF]
, 2007 Research and development work at the University of Southampton using an electrostatic condition monitoring system developed by Smiths Aerospace Information Systems has shown that electrostatic charge signals can be used to detect the onset of wear in ...
Harvey, T.J. +2 more
core +1 more source
Feasibility study on the use of fast camera and recording in time-domain to characterize ESD
MATEC Web of Conferences, 2018 Fire and explosion protection in industrial conditions requires multidimensional approach. Usually the risk of hazardous zone creation is unavoidable, if the combustible material is processed.
Ptak Szymon +2 more
doaj +1 more source
Физика волновых процессов и радиотехнические системы, 2021 In order to further improve the methods of protecting the onboard spacecraft equipment from the effects of electrostatic discharges, based on a comprehensive study of the problem of the occurrence of electrostatic discharges, the authors carried out the ...
Andrei N. Dementiev +2 more
doaj +1 more source
Compact and Broadband ESD Protection I/O Pad Using Pad-Stacked Inductor
IEEE Access, 2023 In this paper, a compact and broadband electrostatic discharge (ESD) protection input/output (I/O) pad for high-speed interfaces is designed and miniaturized using a pad-stacked inductor in a 28-nm CMOS technology. A $\pi $ -diode with a single inductor
Jaehoon Jeong +4 more
doaj +1 more source
Measurement of Flow Characteristics in a Bubbling Fluidized Bed Using Electrostatic Sensor Arrays [PDF]
, 2016 Fluidized beds are widely applied in a range of industrial processes. In order to maintain the efficient operation of a fluidized bed, the flow parameters in the bed should be monitored continuously. In this paper, electrostatic sensor arrays are used to
Yang, Yongrong +3 more
core +1 more source