Results 151 to 160 of about 716,525 (313)
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Gas Exchange Characteristics in Tectona grandis L. Clones under Varying Concentrations of CO2 Levels [PDF]
The Institute of Forest Genetics and Tree Breeding, Coimbatore, India functioning under the Indian Council of Forestry Research and Education, Dehara Dun, has a long term systematic tree improvement program for Tectona grandis aimed to enhancing ...
S. Saravanan
core
This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm +6 more
wiley +1 more source
Carbon‐free inert anodes are essential for decarbonizing aluminum electrolysis. This study investigates a recyclate‐based MgO‐316L steel composite anode tested under galvanostatic Hall–Héroult conditions in cryolite at 1000°C. Microstructural analysis reveals selective MgO fluorination, spinel and oxide layer formation, electrolyte infiltration, and ...
Serhii Yaroshevskyi +7 more
wiley +1 more source
Plant–plant interactions play a critical role in shaping plant communities and influencing ecosystem services. However, how these interactions shift between positive (facilitation) and negative (competition) in response to environmental factors ...
Smriti Pehim Limbu, Meghan L. Avolio
doaj +1 more source
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
A carbon‐free, as‐sintered MgO–steel cermet anode, fabricated via cold isostatic pressing using MgO–C refractory recyclate, was evaluated under laboratory‐scale K‐cryolite electrolysis at 800°C. Operation at this reduced temperature, combined with the electrolyte's limited electrical conductivity, led to an increase in cell voltage.
Farhan Hossain +7 more
wiley +1 more source
Elevated CO2 alters photosynthesis, growth and susceptibility to powdery mildew of oak seedlings. [PDF]
Sanchez-Lucas R +4 more
europepmc +1 more source
Modeling interannual variability in the Martian seasonal CO2 cycle [PDF]
One aspect of the seasonal pressure variations measured at the Viking Lander sites is their nearly perfect interannual repeatability. This presents a problem because it implies that the behavior of the seasonal polar caps should be highly repeatable from
Paige, D. A., Wood, S. E.
core +1 more source

