Results 151 to 160 of about 43,335 (258)

Precipitation and hardening in irradiated low alloy steels with a wide range of Ni and Mn compositions [PDF]

, 2019
Almirall, N, Odette, GR, Riddle, N, Wells, PB, Wilford, K, Williams, T, Yamamoto, T   +6 more
core  

Influence of gaseous hydrogen on metals Interim report [PDF]

Gaseous hydrogen embrittlement in Inconel 718, Inconel 625, AISI 321 stainless steel, Ti-5Al-25Sn ELI, and OFHC ...
Chandler, W. T., Hayes, H. G., Walter, R. J.   +2 more
core   +1 more source

From Mechanics to Electronics: Influence of ALD Interlayers on the Multiaxial Electro‐Mechanical Behavior of Metal–Oxide Bilayers

Advanced Functional Materials, Volume 36, Issue 27, 2 April 2026.
Ultrathin AlOxHy interlayers between aluminum films and polymer substrates significantly improve electro‐mechanical properties of flexible thin film systems. By precisely controlling interlayer thickness using atomic layer deposition, this study identifies an optimal interlayer thickness of 5–10 nm that enhances ductility and delays cracking.
Johanna Byloff, Vivek Devulapalli, Daniele Casari, Thomas E. J. Edwards, Claus O. W. Trost, Megan J. Cordill, Shuhel Altaf Husain, Pierre‐Olivier Renault, Damien Faurie, Barbara Putz   +9 more
wiley   +1 more source

Degradation of Mechanical Properties in HR3C Steel: The Role of σ and M₂₃C₆ Phase Evolution During Long-Term Service. [PDF]

Nanomaterials (Basel)
Li Z, Wang K, Zhang Q, Gong R, Li Y, Yin C, Liu X.   +6 more
europepmc   +1 more source

Effect of exposure cycle on hot salt stress corrosion of a titanium alloy [PDF]

The influence of exposure cycle on the hot-salt stress-corrosion cracking resistance of the Ti-8Al-1Mo-1V alloy was determined. Both temperature and stress were cycled simultaneously to simulate turbine-powered aircraft service cycles.
Gray, H. R., Johnston, J. R.
core   +1 more source

Diffusion and Critical Hydrogen Content of Carbon Steels with Different Strengths and Microstructures. [PDF]

Materials (Basel)
Zwittnig D, Eichinger M, Mülleder M, Schindler C, Egger R, Mori G.   +5 more
europepmc   +1 more source

Some aspects of robotics calibration, design and control [PDF]

The main objective is to introduce techniques in the areas of testing and calibration, design, and control of robotic systems. A statistical technique is described that analyzes a robot's performance and provides quantitative three-dimensional evaluation
Tawfik, Hazem
core   +1 more source

Large‐Scale Hydrogen Storage: Surface and Subsurface Challenges

ChemBioEng Reviews, Volume 13, Issue 2, April 2026.
This review examines underground hydrogen storage with emphasis on the interaction between surface facilities and subsurface reservoirs. Variable renewable hydrogen requires compression, buffering, and purification before injection, while subsurface processes influence wellhead pressure, temperature, and composition.
Mostafa Montazeri, Alireza Salmachi, Manouchehr Haghighi, Tara Hosseini   +3 more
wiley   +1 more source

Segregation passivation makes cost-effective stainless steel resistant to corrosion and hydrogen embrittlement. [PDF]

Sci Adv
Cheng H, Luo H, Li Y, Rao Z, Zhao Q, Pan Z, Kong Q, Li X, Raabe D.   +8 more
europepmc   +1 more source

Effect of PWHT and Electrical Parameters on Austenitic Phase, Sigma Phase and Corrosion in Duplex Steels S32205

Engineering Reports, Volume 8, Issue 4, April 2026.
Welding power and post‐weld heat treatment (PWHT) at 850°C influence phase transformations in S32205 duplex stainless steel, promoting sigma phase formation and reducing corrosion resistance. PWHT at 850°C also replicates HAZ‐like microstructures in base metal, enabling improved characterization of weld joint properties.
Sandra Chacón‐Fernández, José L. Meseguer‐Valdenebro, Andrea Peña Martín   +2 more
wiley   +1 more source