Results 51 to 60 of about 735,757 (309)
Highly effective way in five-axis sculptured surfaces machining using flat-end cutter [PDF]
, 2007 This paper applied the concept of “contact” in Differential Geometry into the machining of the sculptured surface. I presented the contact principle of the machining of complicated surfaces, using the circumference circle of the cylindrical cutter to ...
Huran, Liu +4 more
core
Advanced Engineering Materials, EarlyView.High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin +4 more
wiley +1 more source
Modeling and Simulation Research of Ball End Mill Rake Face
Chemical Engineering Transactions, 2016 According to the structure of the ball end mill and the cutter grinding principle, a mathematic model related to the ball blade rake face and circumference blade rake face was established.
S. Li
doaj +1 more source
The Rainbow Site, An Unusual Syrup Mill in Gregg County, Texas [PDF]
, 2005 The Rainbow site is a historic archaeological site that was recorded during a cultural resources survey of a proposed Wal-Mart SuperCenter site in Longview, Texas. It was first interpreted as the location of an illegal whiskey still, but testing revealed
Skinner, S. Alan
core +1 more source
Surface roughness prediction in milling based on tool displacements [PDF]
, 2011 In this paper, an experimental device using non-contact displacement sensors for the investigation of milling tool behaviour is presented. It enables the recording of high frequency tool vibrations during milling operations.
COSTES, Jean-Philippe, MOREAU, Vincent
core +3 more sources
Advanced Engineering Materials, EarlyView.Carbon nanomaterial‐reinforced epoxy composites exhibit pronounced piezoresistive behavior, enabling intrinsic damage sensing under cyclic and fatigue loading. This review critically compares carbon nanotube and graphene systems, correlating filler content, percolation threshold, and gauge factor with sensing stability and damage evolution.
J. M. Parente +3 more
wiley +1 more source
Performance of laser assisted micro-milling (laμmill) of titanium alloy using micro ball end mill [PDF]
, 2018 Laser assisted milling technique turns to be complicated and unpredictable when the machining size is scaled to micro level. Furthermore, less has been reported on the application of ball end mill in laser assisted micro milling.
Mohid, Zazuli
core
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Comparative analysis of milling results on the tail-end reduction passages of the wheat flour milling process: Conventional vs. eight-roller milling system [PDF]
Hemijska Industrija, 2015 Introduction of the eight-roller mill into the wheat flour milling process significantly reduces the investment costs and overall energy requirements compared to the conventional milling system. However, the conditions for controlled milling are
Fišteš Aleksandar Z.
doaj +1 more source
OPTIMIZATION OF END MILLS PERIPHERY MILLING
Journal of Mechanical Engineering the National Technical University of Ukraine "Kyiv Polytechnic Institute", 2016 A mathematical model is developed for optimization of process of the peripheral milling, which contains the digital method of determination of cutting force, and also equalizations relating limitations with the guided parameters of the cutting mode: by frequency of rotation of spindle and feed-rate.
openaire +2 more sources