Fractal Analysis on Machined Surface Morphologies of Soft-Brittle KDP Crystals Processed by Micro Ball-End Milling. [PDF]
Materials (Basel), 2023 Liu Q +7 more
europepmc +1 more source
Optimization of 5-Axis milling processes based on the process models with application to airfoil machining [PDF]
, 2007 5-axis milling is widely used in machining of complex surfaces such as airfoils. Improper selection of machining parameters may cause low productivity and undesired results during machining.
Budak, Erhan, Tunc, Taner
core
Domain Wall Rebounds Driven by Competing Entropic and Spin‐Transfer Torques in Cylindrical Nanowires
Advanced Functional Materials, EarlyView.Domain‐wall motion in cylindrical magnetic nanowires driven by nanosecond current pulses. Low current densities efficiently displace domain walls, whereas higher currents cause rebound at the wire ends. The effect results from the interplay between spin‐transfer torque and thermally induced processes, highlighting the role of thermal gradients in ...
Elias Saugar +11 more
wiley +1 more source
Experimental Study on Ultrasonic-Assisted End Milling Forces in 2195 Aluminum-Lithium Alloy. [PDF]
Materials (Basel), 2022 Wang H, Zhang S, Li G.
europepmc +1 more source
High Entropy Wide‐Bandgap Borates with Broadband Luminescence and Large Nonlinear Optical properties
Advanced Functional Materials, EarlyView.High‐entropy rare‐earth borates exhibit excellent nonlinear optical and broadband luminescence properties arising from multi‐component doping, chemical disorder, increased configurational entropy, and increased lattice and electronic anharmonicity. This formulation enabled us to obtain a large, environmentally stable single crystal with 3X higher laser‐
Saugata Sarker +14 more
wiley +1 more source
Study on the Formation Mechanism of Surface Adhered Damage in Ball-End Milling Ti6Al4V. [PDF]
Materials (Basel), 2021 Zhang A, Yue C, Liu X, Liang SY.
europepmc +1 more source
Investigation of tool geometry effect and penetration strategies on cutting forces during thread milling [PDF]
, 2014 The application of thread milling is increasing in industry because of its inherent advantages over other thread cutting techniques. The objective of this study is to investigate the effect of milling cutter tool geometry on cutting forces during thread ...
BRENDLEN, Romain +3 more
core +3 more sources
Advanced Functional Materials, EarlyView.Hydrocarbon membranes are a greener alternative to PFSA in PEM fuel cells, but degrade rapidly from radical attack. We present a novel strategy using poly(vinylphosphonic acid) (PVPA) as a local radical scavenger. Incorporated as an interfacial barrier, PVPA enhances chemical stability and significantly extends membrane lifetime under accelerated ...
Hendrik Sannemüller +6 more
wiley +1 more source
The Machining of Hard Mold Steel by Ultrasonic Assisted End Milling
Applied Sciences, 2016 This study describes the use of ultrasonic-assisted end milling to improve the quality of the machined surface of hard Stavax (modified AISI 420) mold steel and to reduce the amount of work involved in the final polishing process.
Ming Yi Tsai +2 more
doaj +1 more source
Generic Cutting Force Modeling with Comprehensively Considering Tool Edge Radius, Tool Flank Wear and Tool Runout in Micro-End Milling. [PDF]
Micromachines (Basel), 2022 Gao S, Duan X, Zhu K, Zhang Y.
europepmc +1 more source