Results 121 to 130 of about 1,353,488 (291)
Optimal strategies for distribution network reconfiguration considering uncertain wind power
CSEE Journal of Power and Energy Systems, 2020 Zhiwei Cui +6 more
doaj +1 more source
Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials
Advanced Engineering Materials, EarlyView.Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai +2 more
wiley +1 more source
The Capacity Configuration of a Cascade Small Hydropower-Pumped Storage–Wind–PV Complementary System
Applied SciencesDistributed renewable energy sources with significant output fluctuations can negatively impact the power grid stability when it is connected to the power grid.
Bin Li +3 more
doaj +1 more source
Impact of forecasting on energy system optimization
Advances in Applied EnergyLinear programs are frequently employed to optimize national energy system models, which are used to find a minimum-cost energy system. For the operation, they assume perfect forecasting of the weather and demands over the whole optimization horizon and can therefore perfectly fit the energy systems’ design and operation.
Florian Peterssen +5 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Safety monitoring method for powerline corridors based on single‐stage detector and visual matching
High VoltageEffective monitoring and early warning of overhead power lines are critical for ensuring power supply stability and personnel safety. However, existing methods that rely solely on single vision or light detection and ranging (LiDAR) have limitations such
Jinheng Li +5 more
doaj +1 more source
Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology
Advanced Engineering Materials, EarlyView.We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham +7 more
wiley +1 more source
Editorial “Thermodynamic Optimization of Industrial Energy Systems”
EntropyThermodynamic optimization of industrial energy systems is crucial for finding solutions to reduce energy consumption and mitigate losses, leading to environmental and economic benefits [...]
Daniel Florez-Orrego +2 more
openaire +4 more sources
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source