Results 41 to 50 of about 515,656 (287)
FEBS Open Bio, EarlyView.Activation of the mitochondrial protein OXR1 increases pSyn129 αSynuclein aggregation by lowering ATP levels and altering mitochondrial membrane potential, particularly in response to MSA‐derived fibrils. In contrast, ablation of the ER protein EMC4 enhances autophagic flux and lysosomal clearance, broadly reducing α‐synuclein aggregates.
Sandesh Neupane +11 more
wiley +1 more source
Miniaturized Environmental Scanning Electron Microscope for In Situ Planetary Studies [PDF]
, 2010 The exploration of remote planetary surfaces calls for the advancement of low power, highly-miniaturized instrumentation. Instruments of this nature that are capable of multiple types of analyses will prove to be particularly useful as we prepare for ...
Abbott, Terry +9 more
core +1 more source
Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling
Advanced Engineering Materials, EarlyView.Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer +3 more
wiley +1 more source
Individual aerosol particles from biomass burning in southern Africa: 2. Compositions and aging of inorganic particles [PDF]
, 2003 Individual aerosol particles collected over southern Africa during the SAFARI 2000 field study were studied using transmission electron microscopy and field- emission scanning electron microscopy.
Buseck, Peter R. +3 more
core +1 more source
Characterizing the performance of the FEI Titan environmental Transmission Electron Microscope / scanning Transmission Electron Microscope [PDF]
Microscopy and Microanalysis, 2010 Extended abstract of a paper presented at Microscopy and Microanalysis 2010 in Portland, Oregon, USA, August 1 – August 5, 2010.
EA Stach +8 more
openaire +1 more source
, 2014 The shrinkage at the cellular level was determined in the transverse plane of wood using an environmental scanning electron microscope (ESEM). The whole procedure is based on pairs of images grabbed with the same imaging conditions (magnification ...
G. Almeida, F. Huber, P. Perre
semanticscholar +1 more source
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Application of an environmental scanning electron microscope to micromechanical fabrication [PDF]
Scanning, 1996 AbstractCurrent advanced methods of micromechanical fabrication require expensive tooling or are restricted to the fabrication of lateral‐shaped microstructures. To overcome these limitations, recent efforts have usedmicroscale additive freeform fabrication (AFF) methods to prototype micromechanical structures.
B. K. Paul, M. Klimkiewicz
openaire +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Insect diversity and composition during the wet and dry seasons in three forest types of Johor, Malaysia [PDF]
, 2015 The insect diversity and abundance in three forest types namely: Endau Rompin (pristine lowland forest) Gunung Ledang (pristine highland forest) and Bukit Soga (degraded lowland forest) in Johor, Malaysia were studied.
Siddiki, Aishatu
core