Results 41 to 50 of about 449,666 (317)
Arthritis Care &Research, EarlyView.Objective The aim of this study was to determine the differences in demographic, serologic, and clinical characteristics between male and female patients with systemic sclerosis (SSc) in an Australian cohort. Methods This was a retrospective observational study using data from the Australian Scleroderma Cohort Study.
Emily Lin +14 more
wiley +1 more source
SmartMatThe development of smart materials capable of underwater self‐healing, mechanical robustness and damage‐healing sensing attributes holds great promise for applications in marine energy exploitation.
Sihan Gu +6 more
doaj +1 more source
Limonene-Based Epoxy: Anhydride Thermoset Reaction Study
Molecules, 2018 The development of epoxy thermosets from renewable resources is of paramount importance in a sustainable development context. In this paper, a novel bio-based epoxy monomer derived from limonene was synthesized without epichlorohydrine and characterized.
Guillaume Couture +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Fracture and Structural IntegrityHybridization of natural fiber composite by incorporating waste- derived fillers has been identified as a promising sustainable technique to develop environmentally friendly and economical composites with enhanced mechanical properties.
Afroz Khan +4 more
doaj +1 more source
Crystals, 2023 Improvements in the performance of electronic devices necessitate the development of polymer materials with heat dissipation properties. Liquid crystalline (LC) epoxies have attracted attention because of the orientation of their polymer network chains ...
Miyuki Harada, Takuya Matsumoto
doaj +1 more source
Design and evaluation of three-phase fibrous composite structures [PDF]
, 1970 Study reveals composite combination evaluations for boron binder reinforcements for unidirectly reinforced boron/epoxy, glass binder reinforcements for unidirectionally reinforced boron/epoxy, and glass binder reinforcements for unidrectionally ...
Dow, N. F., Rosen, B. W.
core +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Kakovost lepilnega spoja med lesom in jeklom
Les, 2018 The aim of the research was to determine the suitability of selected polyurethane and epoxy adhesives for structural bonding of wood and steel. We tested four polyurethane adhesives COSMO and two epoxy adhesives ERGO and XEPOX.
Jaša Saražin, Milan Šernek
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source