Results 71 to 80 of about 672,812 (294)
Advanced Engineering Materials, EarlyView.This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source
Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials
Advanced Engineering Materials, EarlyView.Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Resonance mechanisms of a single line-to-ground fault on ungrounded systems
Archives of Electrical Engineering, 2020 As for a single line-to-ground fault in an ungrounded distribution system, the power-frequency current is too low to detect the fault. The transient current is more palpable than that at a power-frequency of 50 or 60 Hz.
Jun Jinag, Ling Liu
doaj +1 more source
Equivalent Circuit Modeling of the Dielectric Loaded Microwave Biosensor [PDF]
, 2014 This article describes the modeling of biological tissues at microwave frequency using equivalent lumped elements. A microwave biosensor based on microstrip ring resonator (MRR), that has been utilized previously for meat quality evaluation is used for ...
Cheong, L. Y. +4 more
core +1 more source
Linear circuit models for on-chip quantum electrodynamics
, 2011 We present equivalent circuits that model the interaction of microwave resonators and quantum systems. The circuit models are derived from a general interaction Hamiltonian.
Csaba, György +4 more
core +1 more source
A Nonlinear Least Squares Fit procedure for analysis of immittance data of electrochemical systems [PDF]
, 1986 A Nonlinear Least Squares Fit (NLLSF) program is described, with which frequency dispersion data of electrochemical systems can be analyzed in terms of an equivalent circuit.
Boukamp, Bernard A.
core +3 more sources
Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites
Advanced Engineering Materials, EarlyView.Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter +9 more
wiley +1 more source
Complexity, 2018 This paper proposed a novel fractional-order memristor-based chaotic circuit. A memristive diode bridge cascaded with a fractional-order RL filter constitutes the generalized fractional-order memristor.
Ningning Yang +4 more
doaj +1 more source
Equivalent Circuit Modelling of Non-Symmetric Reciprocal Lossy Electromagnetic Structures [PDF]
, 2018 Lattice-network-based equivalent circuits of lossy symmetric reciprocal electromagnetic structures have shown superior performance when compared to other topologies like the T- or PI- networks.
Abdo Sánchez, Elena +3 more
core