Results 41 to 50 of about 36,539 (295)

Down/up conversion luminescence of erbium-ytterbium co-deposited nanoparticles on carbon nanotubes via a microwave-assisted method [PDF]

open access: yesPeerJ Materials Science
In this study we present the synthesis of erbium, ytterbium and erbium-ytterbium nanoparticles supported on multiwalled carbon nanotubes by a microwave-assisted method as well as the evaluation of their luminescent properties.
Martha P. Zapata-Perez   +5 more
doaj   +2 more sources

Effect of Er:YAG laser radiation on pull-out fracture load of esthetic posts luted to root canal dentin with various resin cements

open access: yesDental Research Journal, 2021
Background: This study investigated the influence of erbium-doped: yttrium aluminum garnet (Er:YAG) laser on the pull-out fracture load of fiber-reinforced composite (FRC) posts luted to dentin with different resin cements. Materials and Methods: In this
Horieh Moosavi   +2 more
doaj   +1 more source

Erbium-Excess Gallium Garnets

open access: yesInorganic Chemistry, 2023
A series of garnets of formula Er3+xGa5-xO12 is described, for which we report the crystal structures for both polycrystalline and single-crystal samples. The x limit in the garnet phase is between 0.5 and 0.6 under our conditions, with the Er fully occupying the normal garnet site plus half-occupying the octahedral site at x = 0.5 in place of the Ga ...
Chen Yang   +7 more
openaire   +3 more sources

Mechanochemical Synthesis and Characterization of Nanostructured ErB4 and NdB4 Rare‐Earth Tetraborides

open access: yesAdvanced Engineering Materials, Volume 27, Issue 6, March 2025.
ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur   +5 more
wiley   +1 more source

Ultranarrow-Linewidth Brillouin/Erbium Fiber Laser Based on 45-cm Erbium-Doped Fiber

open access: yesIEEE Photonics Journal, 2015
We demonstrate an ultranarrow-linewidth Brillouin/erbium fiber laser (BEFL), in which 45-cm commercialized erbium-doped fiber (EDF) acts as both the Brillouin and linear gain media. The Brillouin pump threshold of the BEFL is in submilliwatts. Its 980-nm
Mo Chen   +4 more
doaj   +1 more source

Cost-Effective Fabrication of Fractal Silicon Nanowire Arrays

open access: yesNanomaterials, 2021
Silicon nanowires (Si NWs) emerged in several application fields as a strategic element to surpass the bulk limits with a flat compatible architecture.
Antonio Alessio Leonardi   +6 more
doaj   +1 more source

Microgels Enable iPSCs to Assemble, Expand, and Differentiate Into Organoids—From Sizable to High‐Throughput

open access: yesAdvanced Materials, EarlyView.
A chemically defined PEG‐based microgel platform enables scalable, reproducible production of three‐dimensional microgel‐iPSC constructs in multiple sizes. The system is compatible with high‐throughput automation and supports human iPSC expansion and differentiation within a single construct, including directed differentiation into cardiac organoids ...
Laura Klasen   +8 more
wiley   +1 more source

Synthesis of Ti2B2Clx MBenes in Molten Salts From Theoretical and Experimental Perspectives

open access: yesAdvanced Materials, EarlyView.
By integrating a theoretical framework with experiments, Ti2InB2 was selectively etched with ZnCl2 to produce a multilayer (ml) Ti2B2Clx MBene. The In atoms are completely removed, with simultaneous incorporation of chlorine surface terminations. in situ x‐ray diffraction indicates a direct biphasic transformation from Ti2InB2 to ml‐MBene, with no ...
Rodrigo M. Ronchi   +15 more
wiley   +1 more source

Upconversion Luminescence from Sol-Gel-Derived Erbium- and Ytterbium-Doped BaTiO3 Film Structures and the Target Form

open access: yesPhotonics, 2023
Sol-gel technology has attracted attention in the fabrication of diverse luminescent materials and thin film structures, with forms that range from powders to microcavities.
Nikolai V. Gaponenko   +17 more
doaj   +1 more source

Architected Ion Exchange Resins by Vat Photopolymerization 3D Printing for Rare Earth Elements Extraction

open access: yesAdvanced Materials Technologies, EarlyView.
Architected sorbents that combine high surface area with customizable binding sites are attractive materials for liquid‐solid extraction of rare earth elements from hydrometallurgical feedstocks. Here, we report a family of rationally designed, methacrylate‐based ion‐exchange resins and evaluate their performance with a bastnaesite‐derived acid ...
Grant M. Musgrave   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy