Results 131 to 140 of about 117,314 (288)
Quasi-anisotropic wet etching of glass creates inclined microstructures for advanced optical and MEMS devices. [PDF]
Yu J +9 more
europepmc +1 more source
Fe─NC porous oxygen reduction electrocatalysts are prepared employing a 2,4,6‐Triaminopyrimidine‐based porous organic polymer, a Mg2+ Lewis acid, and a low‐temperature cation exchange protocol. Using the polymer precursor achieves high pyrolysis yields and results in atomically dispersed FeNx sites. The resulting catalysts feature hierarchical porosity
Eliot Petitdemange +11 more
wiley +1 more source
Shear bond strength of the adhesive/dentin interface after different etching protocols
Rodrigo Galo +3 more
openalex +2 more sources
Wafer-Level Self-Assembly and Interface Passivation Patterning Technology for Nanomaterial-Compatible 3D MEMS Sensing Chips. [PDF]
Zhang Z +6 more
europepmc +1 more source
It is reported that the ferroelectric switching behavior of rhombohedral (3R) phase transition metal dichalcogenide (TMD) bilayers strongly depends on their domain structures. Single‐domain TMDs (SD‐TMDs) with domain‐wall‐free structures exhibit robust and stable polarization switching, whereas poly‐domain TMDs (PD‐TMDs) with randomly distributed ...
Ji‐Hwan Baek +8 more
wiley +1 more source
Investigation of Silicon Nanowires Produced by Metal-Assisted Chemical Etching Method
Murtadha Alher +2 more
openalex +1 more source
Fabrication of a Superhydrophobic Surface via Wet Etching of a Polydimethylsiloxane Micropillar Array. [PDF]
Pei WH, Hung CC, Juang YJ.
europepmc +1 more source
A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source

