Results 91 to 100 of about 55,668 (311)
Deep eutectic solvents as green and cost-effective supercapacitor electrolytes
Deep eutectic solvents (DESs) have attracted widespread attention as a tempting and capable alternative to traditional electrolytes in energy storage system, particularly in terms of aqueous supercapacitors (SCs).
Pham, Hong Duc +4 more
core +1 more source
Methods for calculating specifi c electrical conductivity of the LiF+NaF mixtures melt [PDF]
Известия Саратовского университета. Новая серия: Серия Химия. Биология. ЭкологияThe calculation of the specifi c electrical conductivity of lithium and sodium fl uorides mixtures melts is presented. The Iinterest in the LiF–NaF system melts is determined by their practical signifi cance.
Lavrenteva, Olga V. +2 more
doaj +1 more source
Epidermal Patch Technologies for Integrated Healthcare and Infection Management
Advanced Healthcare Materials, EarlyView.Epidermal patches have evolved from simple wound coverings into multifunctional, skin‐conformable platforms integrating drug delivery, biosensing, and therapeutic functionalities. This review highlights their material innovations, fabrication strategies, and intelligent designs, including hydrogels, microneedles, and flexible electronics, while ...
Yuqi Wang +7 more
wiley +1 more source
, 2012 Hypereutectic aluminum-silicon (Al-Si) alloys are widely used in the aerospace and automobile industries because of their low density, excellent wear and corrosion resistance, low coefficient of thermal expansion, good strength, and excellent castability.
Plotkowski, Alexander Joseph
core
Electroplated Fe–Ni Films Prepared From Deep Eutectic Solvents
, 2014 Fe-Ni alloy films were prepared by electroplating in a plating bath containing a choline chloride and ethylene glycol-based deep eutectic solvent (DES). The Fe content of the electroplated films was found to vary from 0 at.% to 100 at.% and was dependent
Yanai, Takeshi +6 more
core +1 more source
Forecasting state diagrams two-component salt systems
Вестник Самарского государственного технического университета. Серия: Технические наукиThe article proposes a method for forecasting and approximate calculating the two-component systems characteristics state diagrams. The results for 200 salt systems with a common cation and 100 with a common anion systems statistical analysis of fase ...
Olga S. Afanaseva +2 more
doaj +1 more source
Advanced Healthcare Materials, EarlyView.Microgel‐based 3D printed constructs represent a compelling and versatile innovation for engineering architecturally complex, dynamically remodelable, and biocompatible structures with high structural fidelity and bioactivity. By integrating material design, biofabrication, and biological function, these systems enable the development of adaptive ...
Elena Ghighină +2 more
wiley +1 more source
Grain Growth-Controlled Giant Permittivity in Soft Chemistry CaCu3Ti4O12 Ceramics [PDF]
, 2007 We report a dielectric constant of up to 5.4105 at room temperature and 1 kHz for CaCu3Ti4O12 (CCTO) ceramics, derived from multiphase powders (coprecipitation products), made by a ‘‘chimie douce’’ (coprecipitation) method, and then sintered in air.
Durand, Bernard +5 more
core +1 more source
Journal of Manufacturing and Materials ProcessingIn this study, prospects of designing new Al–Ca–Cu–Mn (Zr) alloys for additive manufacturing (AM) were evaluated for the example of laser remelting of thin-sheet rolled products. The new as-cast alloys have a hypereutectic structure containing Al27Ca3Cu7
Nikolay V. Letyagin +6 more
doaj +1 more source
Thermo-Physical Properties of Selected Inconel
Archives of Metallurgy and Materials, 2014 The paper brings results of examinations of main thermo-physical properties of selected Inconel alloys, i.e. their heat diffusivity, thermal conductivity and heat capacity, measured in wide temperature range of 20 – 900 oC.
Krajewski P.K. +5 more
doaj +1 more source