General methodology for exergy balance in ProSimPlus® process simulator [PDF]
, 2012 This paper presents a general methodology for exergy balance in chemical and thermal processes integrated in ProSimPlus® as a well-adopted process simulator for energy efficiency analysis.
Baudet, Philippe +5 more
core +2 more sources
The comparison of various gas turbine inlet aircooling methods for various ambient condition trough energy and exergy analysis [PDF]
, 2012 The strong influence of climate conditions on gas turbine behavior is well known. During the summer season the output of gas turbines falls to a value that is less than the rated output under high temperature conditions. Cooling the turbine inlet air can
Kaviri, A. Ganjeh +3 more
core +1 more source
Electrotechnological Heat Treatment of Milk: Energy and Exergy Efficiency
Техника и технология пищевых производств, 2023 The dairy industry needs new and more energy-efficient technological procedure for milk pasteurization. This article introduces a comparative efficiency assessment of various milk pasteurization technologies and electrotechnological means.
Andrei A. Bagaev, Sergey O. Bobrovskiy
doaj +1 more source
Desalination Processes’ Efficiency and Future Roadmap [PDF]
, 2019 For future sustainable seawater desalination, the importance of achieving better energy efficiency of the existing 19,500 commercial-scale desalination plants cannot be over emphasized.
Burhan, Muhammad +3 more
core +3 more sources
Exergy Analyses of Onion Drying by Convection: Influence of Dryer Parameters on Performance
Entropy, 2018 This research work is concerned in the exergy analysis of the continuous-convection drying of onion. The influence of temperature and air velocity was studied in terms of exergy parameters.
María Castro +4 more
doaj +1 more source
Exergetic, exergoeconomic and exergoenvironmental analysis of intercooled gas turbine engine [PDF]
, 2016 Exergetic and exergoeconomic and exergoenvironmental analyses have been performed for an advanced aero-derivative intercooled gas turbine engine. The proposed system was modelled using the IPSEpro software package and validated using manufacturer’s ...
Al-Mutawa, Nawaf +2 more
core +1 more source
Experimental investigation of a cascaded organic Rankine cycle plant for the utilization of waste heat at high and low temperature levels [PDF]
, 2020 A power plant with two cascaded organic Rankine cycles (CORC) to exploit waste heat from a 800 kWe combined heat and power plant, fueled by biogas, is designed and tested.
Heim, André +4 more
core +1 more source
Influence of operating parameters on the performance of combined cycle based on exergy analysis
Case Studies in Thermal Engineering, 2022 This paper presents the energy and exergy analysis for actual data of the triple-pressure combined cycle power plant (CCPP). This study was carried out to evaluate each component's power plant efficiency and destruction rate.
Lava Talib Shireef, Thamir K. Ibrahim
doaj +1 more source
Exergy analysis of a PWR nuclear steam supply system – Part I, general theoretical model [PDF]
, 2018 The paper provides an alternative, novel methodology to perform the exergetic analysis of a Pressurized Nuclear Reactor (PWR) based on the strictest definition of fission temperature to get to a careful evaluation of Exergy Destruction and exergetic ...
Ferroni, Luisa, NATALE, ANTONIO
core +1 more source
Advanced Exergy Analysis in the Dynamic Framework for Assessing Building Thermal Systems [PDF]
, 2019 This work applies the Dynamic Advanced Exergy Analysis (DAEA) to a heating and domestic hot water (DHW) facility supplied by a Stirling engine and a condensing boiler. For the first time, an advanced exergy analysis using dynamic conditions is applied to
Picallo-Perez, Ana +3 more
core +1 more source