Results 81 to 90 of about 4,154 (188)
Exergy Efficiency Definitions for Manufacturing Processes
The original application of thermodynamic metrics for manufacturing processes has been under development throughout the last decade. The metrics are based on the second law of thermodynamics. Therefore, the exergy value of both input and output streams is used to quantify them.
Renaldi, Renaldi +3 more
openaire +3 more sources
Efficiency and Losses Analysis of Steam Air Heater from Marine Steam Propulsion Plant
Air heaters are commonly used devices in steam power plants. In base-loaded conventional power plants, air heaters usually use flue gases for air heating.
Josip Orović +2 more
doaj +1 more source
Effects of Installing Different Types of Cooling Fins on the Cold Side of a Thermoelectric Power Generation Device on the Thermal Efficiency and Exergy Efficiency of Power Cable Surface Waste Heat Recovery. [PDF]
Hu Z, de León F, Wang R, Li Y.
europepmc +1 more source
Double-Layer Micro Porous Media Burner from Lean to Rich Fuel Mixture: Analysis of Entropy Generation and Exergy Efficiency. [PDF]
Ismail NC +5 more
europepmc +1 more source
The main objective of the present study is to perform an in-depth exergetic analysis on a downward solar air heater (SAHRR) in two configurations: one incorporating impinging air jets and the other without it utilizing an indoor experimental setup.
M. Harikrishnan +4 more
doaj +1 more source
In this paper, the operation of atmospheric distillation unit (ADU) of Warri refinery was optimized using Artificial Neural Network (ANN) method of optimization and exergy rate profiles (ERP). Optimization of ADU exergy efficiency using nine operating
Funmilayo N. Osuolale, Ambrose N. Anozie
doaj
To reveal the mechanism for high brake thermal efficiency (BTE) of diesel methanol dual fuel (DMDF) engine meeting China VI emission regulations without urea, experimental and computational methods were used to study the exergy distribution with ...
Baodong Ma +3 more
doaj +1 more source
This work proposes the design of a parallel cross-feed multi-effect desalination system with a twin-screw compressor, incorporating water injection to enhance system performance.
Osman Shamet, Mohamed A. Antar
doaj +1 more source
Energy and exergy analyses of a lab-scale open-cycle steam power plant at different boiler pressures
In contrast to conventional steam power plants, which employ high-pressure closed cycles, this study presents energy and exergy analyses of a non-conventional lab-scale steam power plant across different boiler pressures, with an emphasis on the effect ...
Abdul Samad Saleem +3 more
doaj +1 more source
Exergy performance as a measure of building efficiency
Energy Performance (EP) of buildings is expressed by indices. They are representative of primary energy use, or final energy use, or carbon dioxide equivalent emissions. The criterions of indices determination, currently used in calculation procedures, don’t actually seem to meet the needs of check energy resources and related environmental impacts ...
LEONCINI, LORENZO, BALDI, MARTA GIULIA
openaire +1 more source

