Results 101 to 110 of about 142,488 (317)

Interaction of MgO Recyclate‐Based Cermet Anode With KF‐AlF3‐Al2O3 at 800°C During Laboratory Scale Aluminum Molten Salt Electrolysis

open access: yesAdvanced Engineering Materials, EarlyView.
A carbon‐free, as‐sintered MgO–steel cermet anode, fabricated via cold isostatic pressing using MgO–C refractory recyclate, was evaluated under laboratory‐scale K‐cryolite electrolysis at 800°C. Operation at this reduced temperature, combined with the electrolyte's limited electrical conductivity, led to an increase in cell voltage.
Farhan Hossain   +7 more
wiley   +1 more source

Using Ultrasonic Fuel Treatment Technology to Reduce Sulfur Oxide Emissions from Marine Diesel Exhaust Gases

open access: yesEnergies
This paper discusses the use of additional ultrasonic fuel treatment technology to reduce sulfur oxide emissions from marine diesel exhaust gases. The research was conducted on a Bulk Carrier vessel with a deadweight of 64,710 tons with the main engine ...
Sergii Sagin   +5 more
doaj   +1 more source

Interaction of Ladle Slag With Varying SiO2 Content and Recyclate‐Based MgO–C Refractories

open access: yesAdvanced Engineering Materials, EarlyView.
Ladle slags (CaO/Al2O3 = 1) with 1–20 wt% SiO2 were investigated in contact with industrial MgO–C refractories fabricated from fresh magnesia and 50 wt% recyclate. The sessile drop method at 1600°C reveals intensive gas formation, delayed slag infiltration in recyclate‐based samples, and, under high‐SiO2 slag, formation of a dense MgAl2O4‐rich ...
Anton Yehorov   +6 more
wiley   +1 more source

Particulate exhaust emissions from an experimental combustor [PDF]

open access: yes
The concentration of dry particulates (carbon) in the exhaust of an experimental gas turbine combustor was measured at simulated takeoff operating conditions and correlated with the standard smoke-number measurement.
Ingebo, R. D., Norgren, C. T.
core   +1 more source

On-Board Sensor-Based NO x Emissions from Heavy-Duty Diesel Vehicles [PDF]

open access: yes, 2019
Real-world nitrogen oxides (NOx) emissions were estimated using on-board sensor readings from 72 heavy-duty diesel vehicles (HDDVs) equipped with a Selective Catalytic Reduction (SCR) system in California.
Boriboonsomsin, Kanok   +9 more
core   +2 more sources

Incorporation of Selenium into Sol–Gel‐Derived Bioactive Glass: Influence on Glass Structure, Bioactivity, and its Selective Cytotoxicity

open access: yesAdvanced Engineering Materials, EarlyView.
Selenium was incorporated into a sol–gel‐derived bioactive glass to enable sustained therapeutic ion release. The selenium‐containing glass preserved bioactivity while selectively inducing cytotoxicity in osteosarcoma cells and maintaining osteoblastic viability.
Breno Rocha Barrioni   +7 more
wiley   +1 more source

Experimental clean combustor program, phase 2 [PDF]

open access: yes
The alternate fuels investigation objective was to experimentally determine the impacts, if any, on exhaust emissions, performance, and durability characteristics of the hybrid and vorbix low pollution combustor concepts when operated on test fuels which
Peduzzi, A., Roberts, R., Vitti, G. E.
core   +1 more source

Performance, combustion and emissions of a diesel engine operated with reformed EGR. Comparison of diesel and GTL fuelling [PDF]

open access: yes, 2009
This is the post-print version of the final paper published in Fuel. The published article is available from the link below. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other ...
A. Abu-Jrai   +24 more
core   +1 more source

Solid‐State Diffusion and Intermetallic Phase Formation in Roll‐Bonded Mg–Zn Composites With Kirigami‐Patterned Inlay

open access: yesAdvanced Engineering Materials, EarlyView.
Mg–Zn composites with a thickness of 0.21 mm were fabricated using roll bonding of a kirigami‐patterned Mg alloy inlay within a Zn matrix. Thermal activation following this process led to the formation of tailored intermetallic structures, which provided the composite with enhanced flexural strength.
Yaroslav Frolov   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy