Results 71 to 80 of about 18,901 (244)
MetalsIn this paper, the microstructure and mechanical properties at the interface of Incoloy825/X65 bimetallic composite pipe achieved by explosive welding were systematically studied. Results show that a periodic wavy bonding interface was formed between the
Yuwei Sun +5 more
doaj +1 more source
Polymer Composites, EarlyView.Rate‐dependent performance of composite adhesive joints using thermoset and thermoplastic adhesives, in terms of toughness and fatigue behaviour. ABSTRACT A recently developed hot‐melt adhesive (HMA) based on cyclic olefin chemistry, supplied as a transparent, non‐tacky thermoplastic film with a distinctive polymer microstructure, was evaluated in this
Hossein Malekinejad +3 more
wiley +1 more source
Journal of Manufacturing and Materials ProcessingMultilayer composite materials, consisting of layers of aluminum alloy and steel, are used in the manufacturing of large engineering structures, including in the shipbuilding and railcar industries.
Andrey Malakhov +5 more
doaj +1 more source
Polymer Engineering &Science, EarlyView.This review integrates the molecular fundamentals, key challenges, and mitigation strategies in polyolefin 3D printing, focusing on shrinkage, warpage, and adhesion control. It highlights material design approaches using recycled polyolefins and functional fillers to improve printability, mechanical properties, and sustainability in additive ...
Malik Hassan +5 more
wiley +1 more source
The Development of Penetration Charges for Increasing the Efficiency of the Interventions of Fire Rescue Service Units [PDF]
, 2019 During building fires is often necessary to deliver nozzles with water to the desired point of intervention and the wall or ceiling must be penetrated for energy supply and the entrance of persons.
Barčová, Karla +2 more
core +1 more source
Civilized explosive welding: Impact welding of thick aluminum to steel plates without explosives
Journal of Manufacturing Processes, 2018 Abstract In this paper, we report welding of 6.35 mm thick AA5052-H32 and AA1100-H14 plates to mild steel, which was achieved in a laboratory environment by vaporizing foil actuator welding (VFAW). An AA3003-H14 interlayer was used between the AA5052-H32 and the mild steel to improve weldability.
Taeseon Lee +4 more
openaire +2 more sources
Polymer International, EarlyView.An overview and categorization of man‐made per‐ or polyfluoroalkyl substances (PFASs) including low‐molar‐mass and high‐molar‐mass fluorochemicals, and their international regulations is presented. Though certain PFASs are toxic, bioaccumulative and cross the human cellular membranes, others, such as fluoropolymers, are safe, reliable and involved in ...
Bruno Améduri
wiley +1 more source
, 1978 An electroexplosive device is presented which employs a header having contact pins hermetically sealed with glass passing through from a connector end of the header to a cavity filled with a shunt layer of a new nonlinear resistive composition and a heat-
Menichelli, V. J.
core +1 more source
MetalsThis study aims to examine how the collision angle affects the Cu-Ta weld generated by the explosive welding method using molecular dynamics modeling. When two blocks collide, the metallic substrates melt rapidly.
Van-Thuc Nguyen +5 more
doaj +1 more source
steel research international, EarlyView.A CALculation of PHAse Diagrams thermodynamic modeling for Fe–Sn–C system is carried out. The model and the developed database can be used to calculate phase diagrams and thermodynamic properties of this system over wide temperature/composition range, and a part of a larger thermodynamic database for steel and alloy system, and effectively used to ...
Won‐Bum Park +2 more
wiley +1 more source