Results 21 to 30 of about 7,633,646 (255)
Linear Active Disturbance Rejection Control for Three-Phase Voltage-Source PWM Rectifier
Three-phase voltage-source pulse width modulation (PWM) rectifier has been widely employed in various industrial applications. For the traditional dual-loop PI control of three-phase voltage-source PWM rectifier, the voltage loop and current loop have ...
Hucheng He +4 more
doaj +1 more source
The response of the tandem pore potassium channel TASK-3 (K2P9.1) to voltage : gating at the cytoplasmic mouth [PDF]
Although the tandem pore potassium channel TASK-3 is thought to open and shut at its selectivity filter in response to changes of extracellular pH, it is currently unknown whether the channel also shows gating at its inner, cytoplasmic mouth through ...
Feng, J. F. +23 more
core +1 more source
Doubly fed induction generator (DFIG) control process is more complex in the calculations under voltage unbalance condition because of the power oscillations, and the conventional controllers cannot maintain the system in a stable and smooth condition ...
Ali Mirzakhani +2 more
doaj +1 more source
In this paper, the load response-based equivalent model is proposed to develop a more sturdy method for the transmission capability estimation of the power grid. Based on real-time phasor measurement unit (PMU) measurements, the power grid is modelled as
Jian-Hong Liu, Jie-Sheng Cheng
doaj +1 more source
Robust AVR design for the synchronous generator
Conventional automatic voltage regulator (AVR) schemes use thyristor-based rectifiers in which the generator field voltage is varied by changing the thyristor's firing angle.
Lamyaa Y. Ghamri +5 more
doaj +1 more source
In order to improve the dynamic response speed and the steady-state performance of the DC side bus voltage of the wind power grid-connected inverter, a mathematical model of a typical three-phase voltage type PWM (Pulse Width Modulation, PWM) grid ...
Youjie Ma +4 more
doaj +1 more source
An Extended CMOS ISFET Model Incorporating the Physical Design Geometry and the Effects on Performance and Offset Variation [PDF]
17/04/13 meb. Accepted version OK to pub.This paper presents an extended model for the CMOS-based Ion-Sensitive-Field-Effect-Transistor (ISFET), incorporating design parameters associated with the physical geometry of the device.
Liu, Y +14 more
core +1 more source
Voltage-dependent learning in the MTJ.
(A) (Top) A sinusoidal voltage signal with amplitude (strength) Vmax = 0.2 V and frequency ω = 100 Hz is applied to the MTJ. (Bottom) Calculated effective conductance of the MTJ in response to the applied voltage.
Mojtaba Madadi Asl (11419101) +1 more
core +1 more source
A Coupled Thermo-Mechanical Dynamic Characterization of Cylindrical Batteries
Lithium-ion batteries have complicated dynamics and temperature behavior. In this paper, a dynamic system previously developed to characterize the voltage response was extended to estimate the heat generation rate due to the electrochemical reactions ...
Khaled I. Alsharif +6 more
doaj +1 more source

