Results 21 to 30 of about 3,950,284 (345)
, 2018 A mathematical model of loading of the nose-free cutting edges of each insert of the face mill with a spiral-stepped cutting scheme was created. It was established that the size of the cut elements depends on the feed magnitude, the design parameters of ...
Larysa Hlembotska +3 more
semanticscholar +1 more source
Modeling and Simulation Research of Ball End Mill Rake Face
Chemical Engineering Transactions, 2016 According to the structure of the ball end mill and the cutter grinding principle, a mathematic model related to the ball blade rake face and circumference blade rake face was established.
S. Li
doaj +1 more source
, 2015 Hard-to-cut materials such as stainless steels and nickel-based super alloys are widely applied in different critical areas, e.g. , aerospace and automotive components and chemical plants.
Chandra Nath +2 more
semanticscholar +1 more source
Determination of Free α-SiO2 Content in Mill Scale by X-ray Diffraction K Value Method
Yankuang ceshi, 2015 At present, free α-SiO2 content is often determined by the pyrophosphate method and X-ray Diffraction (XRD) method. However, insoluble materials including FeO, Fe3O4 and Fe2O3 in mill scale cannot be decomposed by pyrophosphate, and thus the ...
TANG Meng-qi +3 more
doaj +1 more source
Journal of Agricultural Engineering, 2023 Extra virgin olive oil is constantly gaining interest for its outstanding health and nutritional properties. However, the production process generates roughly four times more waste than the quantity of oil.
Alessio Cappelli +2 more
doaj +1 more source
FTS-based Face Milling of Micro Structures
Procedia CIRP, 2015 This article presents a technical concept and machining possibilities for milling of micro structures with a fast tool servo (FTS). The tool is capable of tool tip displacements with a variable frequency up to 4000 Hz and an amplitude up to 30 μm.
Köhler, J., Seibel, A.
openaire +1 more source
Nihon Kikai Gakkai ronbunshu, 2022 We have developed a small size and high strength spiral bevel gear fabricated by five-axis controlled machining center. In the present report, we propose a novel spiral bevel gear with the rib at the end of face width to reinforce the tooth bending ...
Masahiro SAITO +3 more
doaj +1 more source
Simulation of a finishing operation : milling of a turbine blade and influence of damping [PDF]
, 2012 Milling is used to create very complex geometries and thin parts, such as turbine blades. Irreversible geometric defects may appear during finishing operations when a high surface quality is expected.
BALMES, Etienne +4 more
core +5 more sources
Improvement of face mill design for finishing flat surface parts
Технічна інженеріяThe quality machined surface parts depends on the kinematics cutting process, the processing mode, structural and geometric parameters of the cutting tool, etc.
H.M. Vyhovskyi +3 more
doaj +1 more source
Dataset demonstrating physical properties of recycled wind turbine blade composites
Data in Brief, 2018 Wind turbine blades that face end-of-life recycled mechanically. The recycled material was first comminuted via a hammer-mill through a range of varying screen sizes, resinated and compressed to a final thickness to manufacture second generation ...
Seyed Hossein Mamanpush +3 more
doaj +1 more source