Results 1 to 10 of about 126,534 (164)
Machinability of cast irons at finishing face milling of flat surfaces by superhard materials
Технічна інженерія, 2021 The article presents the result of the analysis of machinability of cast irons with different physical and mechanical properties. The thermal processes that occur in the cutting zone and the influence of cutting modes and geometric parameters of the ...
S.I. , L.Ye. , P.P.
doaj +1 more source
Improving the finishing face milling process of flat surfaces of small width parts
Технічна інженерія, 2021 Face mills equipped with superhard materials find more and more wide application at finishing of high hardness materials. These tools fully reveal the potential at high-speed processing.
H.M. , O.A. , N.O. , L.Ye.
doaj +1 more source
Технічна інженерія, 2023 The wide implementation of finishing face milling processes instead of abrasive treatment processes is explained by their high productivity and the possibility of providing processed surfaces of low roughness with the necessary microrelief.
H.M., O.A. , M.M.
doaj +1 more source
Технічна інженерія, 2023 In recent times, methods of finishing flat surfaces with face mills equipped super-hard materials have become widespread. However, the non-stationarity of the cutting process, which is characteristic of face milling processes, leads to variable ...
H.M. , O.A. , M.M.
doaj +1 more source
Applied Sciences, 2019 In face milling one of the most important parameters of the process quality is the roughness of the machined surface. In many articles, the influence of cutting regimes on the roughness and cutting forces of face milling is considered.
Danil Yurievich Pimenov +8 more
doaj +1 more source
The effect of an organic pentasulfide EP additive in turning and milling operations [PDF]
, 2014 Coopération avec Ecole Centrale LyonBecause a cutting fluid could be equally used for different cutting operations, this study proposed to investigate the behavior of a well-known extreme-pressure additive (pentasulfide) in both turning and milling ...
BIERLA, Aleksandra +4 more
core +4 more sources
Waviness at dry high-speed face milling of some hard steels [PDF]
Metrology and Measurement Systems, 2021 Waviness is a parameter used to complete information on the machined surface state. There is little scientific and technical information on the influence exerted by the cutting conditions and the workpiece material hardness on the values of some ...
Irina Beşliu-Băncescu +2 more
doaj +1 more source
Development of Tool Wear Standards and Wear Mechanism for Micro Milling Ti-6Al-4V Alloy
Metals, 2022 With the rapid development of high-precision-device technology, new demands are put forward for micro milling. The size effect and low cutting energy of micro milling make the process expensive and difficult, especially for Ti-6Al-4V alloys.
Tao Zheng +3 more
doaj +1 more source
Simulations and error analysis of the CNC milling of a face gear tooth with given tool paths
Data in Brief, 2019 This data article gives the validation files to the article “CNC milling of face gears with a novel geometric analysis” [1]. The data is about the simulation and machining error analysis of the CNC milling of a face gear tooth with given tool paths.
Huicheng Yi +3 more
doaj +1 more source
Analysis of the Machining Process of Titanium Ti6Al-4V Parts Manufactured by Wire Arc Additive Manufacturing (WAAM) [PDF]
, 2020 In the current days, the new range of machine tools allows the production of titanium alloy parts for the aeronautical sector through additive technologies.
Alonso, Unai +3 more
core +2 more sources