Results 41 to 50 of about 67,653 (292)
Fracture zygoma and its management our experience [PDF]
, 2013 Zygoma is a very crucial component which maintains facial contour. Fractures involving zygoma isvery common, in fact it is the second most common facial bone to the fractured following facialtrauma (next only to nasal bones).
Arjunan, Karthikeyan +2 more
core +1 more source
Trauma ICU Prevalence Project: the diversity of surgical critical care. [PDF]
, 2019 Background:Surgical critical care is crucial to the care of trauma and surgical patients. This study was designed to provide a contemporary assessment of patient types, injuries, and conditions in intensive care units (ICU) caring for trauma patients ...
+91 more
core +1 more source
Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling
Advanced Engineering Materials, EarlyView.Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer +3 more
wiley +1 more source
The Pattern of Oral and Maxillofacial Injuries Among Patients Attending Muhimbili National Hospital, Dar es salaam, Tanzania [PDF]
, 2012 To determine the pattern of oral and maxillofacial injuries among patients attended at the Muhimbili National Hospital, Dar es Salaam, Tanzania. Descriptive cross-sectional hospital based study.
Kileo, Baraka Fredrick
core
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Cost-based analysis of operative maxillofacial fracture managements
Turkish Journal of Plastic Surgery, 2020 Aims: There is no current study presenting a descriptive cost-based analysis of operative maxillofacial fracture managements in Turkey. Therefore, this study attempted to investigate the overall treatment costs of maxillofacial traumas.
Mehmet Altiparmak +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
A Study Of Orbital Fractures In A Tertiary Health Care Center [PDF]
, 2007 A retrospective study of patients with orbital fractures had 48% patients in the age group of 20 – 40 years with male : female ratio of 10:1. Road traffic accidents (71.43%) were the most common cause followed by injury due to fall (20%).
Chhablani, Jay +5 more
core +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Friction and wear behavior of glasses and ceramics [PDF]
, 1974 Adhesion, friction, and wear behavior of glasses and ionic solids are reviewed. These materials are shown to behave in a manner similar to other solids with respect to adhesion.
AHC Westwood +16 more
core +2 more sources