Results 101 to 110 of about 492,585 (315)
Method for reproducing deterioration of single-link buffer rubber used in railway vehicles
Nihon Kikai Gakkai ronbunshuSingle-link used in rolling stock are an important component that connects the bogie to the car body. They trail and brake the car body according to the acceleration and deceleration of the bogie.
Shogo MAMADA +3 more
doaj +1 more source
Test analysis on influence of welding defects on fatigue life of aluminum alloy plate frames
Zhongguo Jianchuan Yanjiu, 2019 [Objectives] This paper aims to study the influence of welding defects on fatigue life of aluminum alloy plate frame.[Methods] Firstly,use X-ray to detect the welds of the test aluminum alloy plate frames with two gusset joints,and then select two plate ...
Miao Sufei +3 more
doaj +1 more source
Effect of rolling on fatigue crack growth rate of Wire and Arc Additive Manufacture (WAAM) processed Titanium [PDF]
, 2013 Titanium (Ti) alloys have been commonly used in the aerospace industry, not only because they have a high strength-to-weight ratio (comparing to the steels) but also their satisfactory corrosion resistance.
Qiu, Xundong
core
Fatigue crack growth in thin notched woven glass composites under tensile loading. Part I: experimental [PDF]
, 2011 Helicopter blades are made of composite materials mainly loaded in fatigue and have normally relatively thin skins. A through-the-thickness crack could appear in these skins.
Barrau, Jean-Jacques +7 more
core +1 more source
Arthritis Care &Research, EarlyView.Objective Frailty occurs prematurely in rheumatoid arthritis (RA) and is associated with poor health outcomes. We compared the performance of four frailty instruments, including a pragmatic alternative measure using chair sit‐to‐stand (STS), and evaluated their abilities to predict poor health outcomes.
Kylie E. Riggles +14 more
wiley +1 more source
Prediction Method and Verification of Fatigue Life for a Turbine Disk with Bolt Hole
Xibei Gongye Daxue Xuebao, 2019 In order to improve the fatigue life prediction accuracy of FGH96 material for turbine engine at higher stress gradient notch, such as bolt holes, the new mean stress formula is used in this paper, the effect of stress gradient and size effect are ...
doaj +1 more source
A Novel Model of Ultrasonic Fatigue Test in Pure Bending. [PDF]
Materials (Basel), 2022 Yang D +10 more
europepmc +1 more source
, 2004 This paper describes an experimental validation of the fatigue damaging events that were identified and extracted using a wavelet-based fatigue data editing technique.
Abdullah, S +7 more
core
, 2015 The influence of hydrogen on the high cycle fatigue (HCF) behaviour of Inconel 718 has been studied at room temperature in asymmetric push–pull mode using an ultrasonic HCF test rig. Fatigue tests have been carried out in gaseous hydrogen (GH2) and in Ar
Fischer, B. +10 more
core +1 more source
Optimum Design of Primary Rubber Traction Joints for a Linear Motor Bogie
机车电传动, 2019 Starting from the failure of imported rubber elastic components used in a linear motor bogie, the domestic development of the rubber elastic components was carried out.
Yong DONG +4 more
doaj