Results 21 to 30 of about 11,042 (303)
An ANN-based protection technique for MTDC systems with multiple configurations
A unified protection technique for different configurations of Multi-Terminal high voltage Direct Current (MTDC) systems is presented in this paper. The technique is based on using positive and negative poles’ currents of one end for each line.
Ahmed E.B. Abu-Elanien, M.M.A. Salama
doaj +1 more source
Signal-based Technique for Fault Detection and Isolation of Inverter Faults in Multi-phase Drives [PDF]
A method for fault detection and isolation is proposed and applied to inverter faults in multi-phase drives. An analysis of simulations in faulty conditions leads to the derivation of suitable fault indices.
Bassel Aslan +14 more
core +1 more source
With the increased demand for permanent magnet synchronous machines (PMSMs) in various industrial fields, interturn short fault (ITSF) diagnosis of PMSMs is under the limelight.
Kim, Seongyun +7 more
core +1 more source
Fault-tolerant operation of single-phase SR generators [PDF]
This paper studies fault-tolerant operation of multipole single-phase switched reluctance generators (SRGs), in particular, an 8/8-pole switched reluctance machine.
Sawata, T. +4 more
core +1 more source
Shown the principle for calculation of double-fault ground current on a branch of electric power network with two sources (one of the sources can be a wind electric plant while the other source can be a power line).
Р.О.Буйний +3 more
doaj +1 more source
A Method for Fault Detection and Isolation based on the Processing of Multiple Diagnostic Indices: Application to Inverter Faults in AC Drives [PDF]
A general method for fault detection and isolation is proposed and applied to inverter faults in drives of electric vehicles. This method is based on a change-detection algorithm, which allows multiple fault indices to be combined for retrieving the most
KESTELYN, Xavier +7 more
core +1 more source
The electric field in northern England and southern Scotland: implications for geomagnetically induced currents. [PDF]
Magnetotelluric (MT) data, in the form of MT tensors, are used to estimate directly the size and spatial distribution of the electric field in northern England and southern Scotland with the aim of predicting the flow of geomagnetically induced currents ...
McKay, A. J. +3 more
core +1 more source
This paper proposes an algorithm for detection and identification of the location of short circuit faults in islanded AC microgrids (MGs) with meshed topology.
Alireza Forouzesh +3 more
doaj +1 more source
Inter-turn short circuit in the excitation windings of synchronous condensers is a common fault that directly impacts their normal operation. However, current fault analysis and diagnosis of synchronous condensers primarily rely on voltage-balanced ...
Junqing Li +5 more
doaj +1 more source
Superconducting fault current limiter application in a power-dense marine electrical system
Power-dense, low-voltage marine electrical systems have the potential for extremely high fault currents. Superconducting fault current limiters (SFCLs) have been of interest for many years and offer an effective method for reducing fault currents.
Burt, Graeme +11 more
core +1 more source

