Results 1 to 10 of about 12,788 (262)
Fault Isolation and Estimation in Networks of Linear Process Systems [PDF]
Entropy, 2023 Fault detection and isolation is a ubiquitous task in current complex systems even in the linear networked case when the complexity is mainly caused by the complex network structure.
Wijaya Kurniawan +2 more
doaj +2 more sources
Active Fault Isolation for Multimode Fault Systems Based on a Set Separation Indicator [PDF]
Entropy, 2023 This paper considers the active fault isolation problem for a class of uncertain multimode fault systems with a high-dimensional state-space model. It has been observed that the existing approaches in the literature based on a steady-state active fault ...
Kezhen Han +3 more
doaj +2 more sources
IEEE Access, 2023 This paper covers model-based fault detection and isolation for linear and nonlinear distributed parameter systems (DPS). The first part mainly deals with actuator, sensor and state fault detection and isolation for a class of DPS represented by a set of
Hasan Ferdowsi +2 more
doaj +1 more source
Actuator and Sensor Fault Detection and Isolation System Applied to a Distillation Column
IEEE Access, 2023 This article presents the results of the simulation of a binary distillation column for which a composition controller and fault detection and isolation strategy was applied.
Gerardo Ortiz-Torres +5 more
doaj +1 more source
Fault isolation procedure analysis method based on dynamic fault tree
Hangkong gongcheng jinzhan, 2023 The traditional fault isolation program uses the conventional static fault tree for fault analysis,which may lead to incomplete fault cause analysis,too cumbersome fault isolation path and other problems.
KE Qianyun, TU Zhiqi, LIU Yaqi
doaj +1 more source
Applied Sciences, 2023 Tunnels may suffer severe damage when passing through an active fault in high-intensity earthquake zones. The present study aims to investigate the performance of an isolation layer composed of a rubber-sand mixture, an emerging trend in low-cost seismic
Shuquan Peng +6 more
doaj +1 more source
Real-Time Neural Classifiers for Sensor and Actuator Faults in Three-Phase Induction Motors
Machines, 2022 The main steps involved in a fault-tolerant control (FTC) scheme are the detection of failures, isolation and reconfiguration of control. Fault detection and isolation (FDI) is a topic of interest due to its importance for the controller, since it ...
Oscar D. Sanchez +3 more
doaj +1 more source
Fault Detection and Isolation of the Multi-Sensor Inertial System
Micromachines, 2021 In order to solve the problem that the generalized likelihood test method cannot isolate the single fault of the four-gyro system and the double faults of the six-gyro system, a fault detection and isolation method combining the generalized likelihood ...
Hao Liang, Yu Guo, Xingfa Zhao
doaj +1 more source
Delays in fault detection and isolation [PDF]
Proceedings of the 2001 American Control Conference. (Cat. No.01CH37148), 2001 Studies an aspect of detection and isolation delays which has been ignored in many papers in this area. Surprising since it is highly relevant from a practical point of view. In continuous-time systems this is not a serious matter since we can always guarantee an arbitrary small delay and nearly all designs in the literature yield this arbitrary small ...
Stoorvogel, Antonie Arij +2 more
openaire +2 more sources
Fault isolability with different forms of the faults–symptoms relation [PDF]
International Journal of Applied Mathematics and Computer Science, 2016 AbstractThe definitions and conditions for fault isolability of single faults for various forms of the diagnostic relation are reviewed. Fault isolability and unisolability on the basis of a binary diagnostic matrix are analyzed. Definitions for conditional and unconditional isolability and unisolability on the basis of a fault information system (FIS),
Jan Maciej Kóscielny +3 more
openaire +3 more sources