Multi-physics based Simulations of an Oleo-pneumatic Shock Absorber System for PHM
International Journal of Prognostics and Health Management, 2017 The paper presents multi-physics (Mechanical, Thermal, Hydraulic, and Pneumatic) based modelling and simulation of an Oleo-pneumatic shock absorber with fault capabilities. The fault simulated in this model is leakage due to eccentricity.
Krishna Lok S., Khazi M. M. Siddiqui
doaj +1 more source
Formal verification of a software countermeasure against instruction skip attacks [PDF]
, 2013 Fault attacks against embedded circuits enabled to define many new attack paths against secure circuits. Every attack path relies on a specific fault model which defines the type of faults that the attacker can perform.
Encrenaz, Emmanuelle +3 more
core +7 more sources
Representing Small Commercial Building Faults in EnergyPlus, Part II: Model Validation
Buildings, 2019 Automated fault detection and diagnosis (AFDD) tools based on machine-learning algorithms hold promise for lowering cost barriers for AFDD in small commercial buildings; however, access to high-quality training data for such algorithms is often difficult
Janghyun Kim +5 more
doaj +1 more source
Sensor-fault tolerance using robust MPC with set-based state estimation and active fault isolation [PDF]
, 2014 In this paper, a sensor fault-tolerant control (FTC) scheme using robust model predictive control (MPC) and set theoretic fault detection and isolation (FDI) is proposed.
Niculescu, Silviu-Iulian +4 more
core +3 more sources
Faultanalysis of Short Circuit Between Pieces of Large Motor Stator Cores
Journal of Harbin University of Science and Technology, 2020 In order to analyze the short circuit fault between the stator core pieces of large motors, the establishment of the fault model was studied. According to the homogenization theory, the shortcircuit fault model between iron cores is studied.
MENG Dawei, WANG Xiaohui
doaj +1 more source
Fault localization models in debugging [PDF]
2017 International Conference on Infocom Technologies and Unmanned Systems (Trends and Future Directions) (ICTUS), 2017 58 ...
Soomro, Safeeullah +3 more
openaire +2 more sources
New combined model of high impedance arcing fault in overhead transmission system [PDF]
, 2012 High impedance fault is a popular complex phenomenon that exhibits high nonlinear behavior. For most distinctive characteristics of high impedance fault, are asymmetry and nonlinearity, so, in order to obtain an accurate model of high impedance fault, it
A. Abohagar, Abdulhamid +1 more
core +1 more source
Dynamic Analysis Method for Fault Propagation Behaviour of Machining Centres
Applied Sciences, 2021 Fault propagation behaviour analysis is the basis of fault diagnosis and health maintenance. Traditional fault propagation studies are mostly based on a priori knowledge of a causality model combined with rule-based reasoning, disregarding the ...
Liming Mu +4 more
doaj +1 more source
An Effective EMTR-Based High-Impedance Fault Location Method for Transmission Lines
, 2020 This paper summarizes the electromagnetic time reversal (EMTR) technique for fault location, and further numerically validates its effectiveness when the fault impedance is negligible. In addition, a specific EMTR model considering the fault impedance is
An, Jianwei +3 more
core +1 more source
THE SAMOA TSUNAMI OF 29 SEPTEMBER 2009 Early Warning and Inundation Assessment [PDF]
Science of Tsunami Hazards, 2012 On 29 September 2009 at 17:48:11 UTC, a large earthquake of magnitude 8 struck off-shore of the Samoa Islands and generated a large tsunami that destroyed several villages and caused more than 160 fatalities.
Giovanni Franchello +1 more
doaj