Results 21 to 30 of about 64,489 (314)
Second phase precipitation in ultrafine-grained ferrite steel [PDF]
Grain size refinement is one of the most efficient strengthening mechanisms applied to modern High-Strength Low-Alloy steels (HSLA) because yield strength and toughness are both improved.
Juno Gallego +3 more
doaj +1 more source
Ferrite material Characterization Using S-Parameters Data [PDF]
ince many applications rely on the knowledge of the electromagnetic material properties of ferrites, such as ferrite phase shifters, this paper presents an algorithm for characterizing ferrite materials in a single frequency using a rectangular waveguide
M. Maleki +2 more
doaj +1 more source
Effect of interlamellar spacing on the elastoplastic behavior of C70 pearlitic steel: Experimental results and self-consistent modeling [PDF]
The effect of pearlite microstructure characteristics on strength and deformation of C70 pearlitic steel was investigated. Tensile tests under X-ray diffraction coupled with self-consistent model have been used to identify the role of interlamellar ...
BACZMANSKI, Andrzej +4 more
core +1 more source
Introduction. The creation of a modern electronic component base with improved characteristics is possible with the use of new materials and technologies for their manufacture. Therefore, it is important to analyze the electrical parameters of electronic
I. G. Mironenko +8 more
doaj +1 more source
Magnetic Materials: Novel Monitors of Long-Term Evolution of Engineered Barrier Systems
Most safety cases for the deep geological disposal of radioactive waste are reliant on the swelling of bentonite in the engineered barrier system as it saturates with groundwater.
Simon L. Harley +2 more
doaj +1 more source
The study of the structural components of Fe-Mn-Si-Ti-Al-N-C with the carbon content of 0.50-0.60% (wt.), Silicon 0.80-0.90% (wt.), Manganese 0.90-0.95% ( wt.
Nataliia Filonenko +3 more
doaj +1 more source
Nanoparticle influence into the structure of structural steel
It is shown in result of the analysis of nanoparticle production processes that among the numerous methods of metal nanoparticle producing, the electrospark granule processing in liquids allows to obtain nano-objects at high temperatures, pressures, and ...
Aftandiliants I.G. , Lopatko К.G.
doaj +1 more source
Evaluation of the magnetization direction effects on ferrite PM brushless fractional machines [PDF]
Permanent magnets are frequently adopted in small brushless machines for automotive applications. Normally anisotropic ferrites, but some research on bonded magnets is being carried on.
P. Ferraris +7 more
core +1 more source
Oxidation kinetics of a Ni-Cu based cermet at high temperature [PDF]
The oxidation kinetics of a cermet composed of Ni–Cu alloy and nickel ferrite was studied by thermogravimetry at 960 °C under oxygen in the range 0.5–77 kPa. After an initial mass increase up to 15 g/m2 due to oxidation of surface metallic particles, the
Palau, Patrice +14 more
core +1 more source
High-quality nanostructure of dysprosium substituted nickel–cobalt ferrite and their composite with reduced graphene oxide (rGO) were synthesized. The structuraland photocatalytic properties of prepared samples were studied.
Muhammad Shahid +6 more
doaj +1 more source

