Results 31 to 40 of about 134,058 (297)
, 2012 Ferrite cavities are used in synchrotrons and storage rings if the maximum RF frequency is in the order of a few MHz. We present a simple model for describing ferrite cavities.
Klingbeil, H.
core +1 more source
, 2011 We report the analysis of measurements of the complex magnetic permeability ($\mu_r$) and dielectric permittivity ($\epsilon_r$) spectra of a rubber radar absorbing material (RAM) with various MnZn ferrite volume fractions.
Dantas, Christine C. +2 more
core +1 more source
Journal of Taibah University for Science, 2020 High-quality nanostructure of dysprosium substituted nickel–cobalt ferrite and their composite with reduced graphene oxide (rGO) were synthesized. The structuraland photocatalytic properties of prepared samples were studied.
Muhammad Shahid +6 more
doaj +1 more source
Preparation and electrical properties of dense micro-cermets made of nickel ferrite and metallic copper [PDF]
, 2009 Dense micro-cermets made of nickel ferrites and copper micrometric particles were obtained from partial reduction under hydrogenated atmosphere at 350 C of mixed copper nickel ferrites, and sintering in nitrogen at 980 C.
Baco-Carles, Valérie +4 more
core +3 more sources
Physical Modeling of Core Losses in Ferrite E-Cores
IEEE Open Journal of Power ElectronicsThe development of advanced power electronic converters requires an accurate calculation of core losses in magnetic devices. But the losses in the widely used ferrite cores depend on the shape of the core, especially above 10 kHz, meaning that core ...
Theophane Dimier, Jurgen Biela
doaj +1 more source
Wireless Power Transfer for High-precision Position Detection of Railroad Vehicles
, 2015 Detection of vehicle position is critical for successful operation of intelligent transportation system. In case of railroad transportation systems, position information of railroad vehicles can be detected by GPS, track circuits, and so on.
Har, Dongsoo, Ryu, Hyun-Gyu
core +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
High chrome cast iron for mineral processing and conveying equipment parts
Литьë и металлургия, 2022 The main reasons for the formation of microand macrocracks and other defects in waterjet castings, which significantly reduce their service life, are analyzed.
A. S. Gudenko +3 more
doaj +1 more source
Dispersion strengthening in vanadium microalloyed steels processed by simulated thin slab casting and direct charging: Part I - Processing parameters, mechanical properties and microstructure [PDF]
, 2007 A study simulating thin slab continuous casting followed by direct charging into an equalisation furnace has been undertaken based on six low carbon (0.06wt-%) vanadium microalloyed steels.
Baker, T.N. +5 more
core +1 more source
Advanced Engineering Materials, EarlyView.Cladding is a proven method that boosts the surface qualities of mechanical parts by applying a layer of more durable material over a base substrate. This work responds to the needs of offshore and pressure vessels sectors by focusing on cladding a super austenitic steel onto low‐carbon steel through gas tungsten arc welding.
E. J. da Cruz Junior +6 more
wiley +1 more source