Results 91 to 100 of about 5,853,371 (124)
Some of the next articles are maybe not open access.
Optics Communications, 2023
The transmission capacity of optical fiber communication can be effectively improved by the combination of dual-polarization (DP) high-order modulation format with mode division multiplexing (MDM) technology. We build up an experimental system for amplification and transmission of DP-MDM signals with orthogonal mode combination (OMC) and identical mode
Wei Yan +5 more
openaire +1 more source
The transmission capacity of optical fiber communication can be effectively improved by the combination of dual-polarization (DP) high-order modulation format with mode division multiplexing (MDM) technology. We build up an experimental system for amplification and transmission of DP-MDM signals with orthogonal mode combination (OMC) and identical mode
Wei Yan +5 more
openaire +1 more source
Optical Fiber Communication Conference/National Fiber Optic Engineers Conference 2013, 2013
We measure the modal gain and noise figure characteristics of a ring-doped few-mode erbium-doped fiber amplifier. We obtained 1 dB higher gain in LP11 than LP01 at an average of 12.5 dB per mode.
Ezra Ip +7 more
openaire +1 more source
We measure the modal gain and noise figure characteristics of a ring-doped few-mode erbium-doped fiber amplifier. We obtained 1 dB higher gain in LP11 than LP01 at an average of 12.5 dB per mode.
Ezra Ip +7 more
openaire +1 more source
Optical Fiber Communication Conference, 2015
We analyze the impact of beating effects between signal modes experimentally by comparing gain values for modulated and CW signals. We measure noticeable differences because of mode beating and mode dependent EDFA saturation.
Simon Akhtari +3 more
openaire +1 more source
We analyze the impact of beating effects between signal modes experimentally by comparing gain values for modulated and CW signals. We measure noticeable differences because of mode beating and mode dependent EDFA saturation.
Simon Akhtari +3 more
openaire +1 more source
Few-mode erbium-doped fiber amplifier design method based on the signal-pump overlap integral
Optical Engineering, 2014Space-division multiplexing allows an increase of link capacity by using either multicore or single-core few-mode (FM) optical fibers. In the case of FM systems, each mode carries its own data stream and long-haul transmission can be hampered by the use of conventional erbium-doped fiber amplifiers (EDFAs), since because of distinct field profile ...
Adolfo F. Herbster, Murilo A. Romero
openaire +1 more source
Few-Mode Erbium-Doped Fiber Amplifier Design Challenges for WDM Optical Networks
2019 SBFoton International Optics and Photonics Conference (SBFoton IOPC), 2019The use of optical spatial division multiplexing (SDM) technologies increases the capacity of the optical channel, allowing higher transmission rates than those observed in wavelength division multiplexing (WDM) optical systems based on single-mode fibers.
openaire +1 more source
Optical Engineering, 2017
We develop a rigorous procedure for the optimum design of few-mode erbium (Er)-doped fiber amplifiers, which is tackled as a multiobjective optimization problem, in an approach based on the combination of the topology optimization and genetic algorithm techniques.
Adolfo F. Herbster, Murilo A. Romero
openaire +1 more source
We develop a rigorous procedure for the optimum design of few-mode erbium (Er)-doped fiber amplifiers, which is tackled as a multiobjective optimization problem, in an approach based on the combination of the topology optimization and genetic algorithm techniques.
Adolfo F. Herbster, Murilo A. Romero
openaire +1 more source
Optimized Two-Stage Few-Mode Erbium Doped Fiber Amplifier
2023 SBMO/IEEE MTT-S International Microwave and Optoelectronics Conference (IMOC), 2023Astrid Lozada, Ricardo Olivares
openaire +1 more source
Journal of Lightwave Technology, 2015
Gradient descent optimization algorithm is applied to design few-mode Er $^{3+}$ -doped fibers adapted to gain equalization over modes and wavelengths, for mode division multiplexing. Theoretical study is performed for fiber designs supporting six and ten spatial modes at signal wavelength.
Guillaume Le Cocq +2 more
openaire +1 more source
Gradient descent optimization algorithm is applied to design few-mode Er $^{3+}$ -doped fibers adapted to gain equalization over modes and wavelengths, for mode division multiplexing. Theoretical study is performed for fiber designs supporting six and ten spatial modes at signal wavelength.
Guillaume Le Cocq +2 more
openaire +1 more source
Chinese Optics Letters, 2018
A few-mode erbium-doped fiber (FM-EDF) is fabricated using modified chemical vapor deposition in combination with liquid solution. The core and cladding diameters of the fiber are approximately 19.44 and 124.12 μm, respectively. The refractive index difference is 0.98%, numerical aperture (NA) is 0.17, and normalized cut-off frequency at 1550 nm is 6 ...
Jianfei Xing Jianfei Xing +6 more
openaire +1 more source
A few-mode erbium-doped fiber (FM-EDF) is fabricated using modified chemical vapor deposition in combination with liquid solution. The core and cladding diameters of the fiber are approximately 19.44 and 124.12 μm, respectively. The refractive index difference is 0.98%, numerical aperture (NA) is 0.17, and normalized cut-off frequency at 1550 nm is 6 ...
Jianfei Xing Jianfei Xing +6 more
openaire +1 more source
Few-mode erbium-doped fiber amplifier for mode-division multiplexed transmission
Fourteenth International Conference on Information Optics and Photonics (CIOP 2023), 2023Yuanpeng Ding +8 more
openaire +1 more source

