Results 291 to 300 of about 1,804,643 (357)
Some of the next articles are maybe not open access.

High Spatial Density 6-Mode 7-Core Fiber Amplifier for L-Band Operation

Journal of Lightwave Technology, 2020
We present a high spatial density space division multiplexed fiber amplifier (i.e., 6-mode 7-core multicore fiber amplifier) supporting 42 spatial channels. A high average modal gain of 23.1 dB is obtained in the L-band with an average differential modal
Yongmin Jung   +2 more
exaly   +2 more sources

1.1 kW, beam-combinable thulium doped all-fiber amplifier

LASE, 2021
A 1.1 kW CW fiber amplifier emitting at 1.95µm and phase modulated at 5 GHz, with 51% optical conversion efficiency and near diffraction limited beam quality ...
B. Anderson, J. Solomon, A. Flores
semanticscholar   +1 more source

7.1 kW coherent beam combining system based on a seven-channel fiber amplifier array

, 2021
Coherently combining of seven-channel narrow-linewidth, linear-polarized, kW-level power all-fiber amplifiers has been successfully demonstrated by using the stochastic parallel gradient descent (SPGD) algorithm.
P. Ma   +12 more
semanticscholar   +1 more source

Bidirectional fiber amplifiers

IEEE Photonics Technology Letters, 1992
The authors propose new bidirectional erbium-doped fiber amplifier repeaters for bidirectional fiber networks and OTDR fault detection. At each repeater the counterpropagating signals are separated, amplified separately, and then recombined. Signal separation is done by directional couplers with intrinsic 6-dB coupling loss, or by optical circulators ...
Barnard, C.W.   +2 more
openaire   +2 more sources

Pump Laser Automatic Signal Control for Erbium-Doped Fiber Amplifier Gain, Noise Figure, and Output Spectral Power

Journal of optical communications, 2019
This paper has simulated the pump laser automatic signal control for erbium-doped fiber amplifier gain, noise figure, and output spectral power. Signal gain and noise figure are deeply studied in relation to laser pump power variations at operating ...
I. Amiri, A. Rashed, P. Yupapin
semanticscholar   +1 more source

Long span fiber amplifiers

Applied Optics, 1990
We examine the theory of optical amplification in long span single-mode fibers which have low levels of erbium dopant. When pumped from the transmitter end at a suitable wavelength, lightly doped fibers can form a distributed amplifier, capable of overcoming transmission losses due to the intrinsic attenuation of the host glass at the signal wavelength.
P, Urquhart, T J, Whitley
openaire   +2 more sources

Simple Broadband Bismuth Doped Fiber Amplifier (BDFA) to Extend O-Band Transmission Reach and Capacity

Optical Fiber Communications Conference and Exhibition, 2019
We developed a simple silica-based BDFA with 80nm 6-dB gain-bandwidth flexibly centred within 1305–1325nm, and parameters comparable to EDFAs. The amplifier can extend 400GBASE-LR8 transmission (8×26.6 Gbaud/s PAM-4 channels) beyond 50 km of G.652 fiber.
V. Mikhailov   +16 more
semanticscholar   +1 more source

Theoretical investigation on Raman Fiber Amplifiers

Asia Communications and Photonics Conference and Exhibition, 2010
The characterization of RFAs with bi-directional Raman pumped or co-propagating Raman pumped is studied. The effection to RFAs for pump power, initial signal power and fiber length is analyzed, which is to optimize and improve gain of RFASSs, so as to improve the performance of the amplifier.
Shuhua Li   +3 more
openaire   +1 more source

Fiber Amplifiers for SDM Systems

Optical Fiber Communication Conference/National Fiber Optic Engineers Conference 2013, 2013
Major advances made in both MCF and MMF amplification is presented here, including scaling up to 6 channels for MMF and up to 7 channels for MCF. EDFA and Raman based approaches and TDFA for PBGF are also demonstrated.
openaire   +2 more sources

Home - About - Disclaimer - Privacy