Results 1 to 10 of about 7,052 (147)
All-fiber orbital angular momentum (OAM) amplifier with high purity and broadband spectrum gain based on a fused taper vortex-beam coupler (VBC) has been studied.
Jianxiang Wen +7 more
doaj +1 more source
We demonstrate a compact all-fiber Er-doped chirped pulse amplification (CPA) system that can produce ∼344 fs pulses with an average power of up to 1.02 W and a repetition rate of 40.6 MHz at 1.56 μm (corresponding to an energy of 25.1 nJ).
Rongling Wei +8 more
doaj +1 more source
Broadband phase coherence between an ultrafast laser and an OPO using lock-to-zero CEO stabilization [PDF]
The carrier-envelope-offset frequencies of the pump, signal, idler and related second-harmonic and sum-frequency mixing pulses have been locked to 0 Hz in a 20-fs-Ti: sapphire-pumped optical parametric oscillator, satisfying a critical prerequisite for ...
Leburn, Christopher G. +3 more
core +1 more source
A 20 W, Less-Than-1-kHz Linewidth Linearly Polarized All-Fiber Laser
We report a continuous-wave high-output power and narrow-linewidth all-fiber laser at 1550 nm with the master oscillator power amplifier (MOPA) configuration. An all-fiber distributed feedback seed laser was boosted by three cascaded fiber amplifiers. In
Mingyuan Xue +6 more
doaj +1 more source
Supercontinuum (SC) generation directly from an Ytterbium-doped fiber amplifier (YDFA) has many advantages such as high output power, low splicing loss, and high optical to optical conversion efficiency.
Chengmin Lei +4 more
doaj +1 more source
Sub two-cycle soliton-effect pulse compression at 800 nm in Photonic Crystal Fibers [PDF]
The possibility of soliton self-compression of ultrashort laser pulses down to the few-cycle regime in photonic crystal fibers is numerically investigated.
Ahmed +27 more
core +2 more sources
Beam Transmission Properties in High Power Ytterbium-Doped Tandem-Pumping Fiber Amplifier
This paper presented beam evolution in entire fiber laser from a more qualitative perspective. Specifically, the beam transmission properties under the condition of the disturbances of the refraction index, during the full length of active fiber in ...
Ping Yan +7 more
doaj +1 more source
A Comparison of Laser and Microwave Approaches to CW Beamed Energy Launch [PDF]
One approach to beamed energy propulsion uses a solid heat exchanger to absorb energy from a distant source and transfer it to a working fluid. Systems of this type can be designed using either microwave or laser sources.
Kare, Jordin T., Parkin, Kevin L. G.
core +1 more source
We fully demonstrated an ytterbium (Yb) doped triple-clad laser fiber with intense pump absorption, high efficiency, and laser stability. P5+/Al3+ molar ratio in the central region of fiber core was specially designed to be ∼1.
Shuang Liu +12 more
doaj +1 more source
Suppression of stimulated Brillouin scattering in optical fibers using a linearly chirped diode laser [PDF]
The output of high power fiber amplifiers is typically limited by stimulated Brillouin scattering (SBS). An analysis of SBS with a chirped pump laser indicates that a chirp of 2.5 × 10^(15) Hz/s could raise, by an order of magnitude, the SBS threshold ...
Cahill, J. P. +7 more
core +1 more source

