Results 91 to 100 of about 3,736,666 (310)
Efficient lithium extraction from brines remains challenging due to the comparable hydrated radii of Li+ and Mg2+ and the extreme ionic strength of the feed solutions. In this work, a reconstructed polyamide (PA) nanofiltration membrane was developed via
Shuzhen Zhao +9 more
doaj +1 more source
Modeling the buckling and delamination of thin films
I study numerically the problem of delamination of a thin film elastically attached to a rigid substrate. A nominally flat elastic thin film is modeled using a two-dimensional triangular mesh.
E. A. Jagla +3 more
core +1 more source
Oxide‐Free Titanium Coatings by Wire Arc Spraying in a Silane‐Doped Inert Atmosphere
A silane‐doped argon atmosphere enables the production of oxide‐free titanium coatings via twin‐wire arc spraying at ambient pressure. This innovative approach eliminates residual oxygen, creating process conditions that prevent oxidation and nitride formation.
Manuel Rodriguez Diaz +4 more
wiley +1 more source
Precise separation of Li+/Mg2+ with similar ionic size remains a critical challenge for two‐dimensional (2D) membranes, largely due to the inherently tortuous and poorly regulated transport channels in the 2D interlayer.
Liheng Dai +9 more
doaj +1 more source
The Impact of Physical Props and Physics-Associated Visual Feedback on VR Archery Performance
Most existing virtual reality exergames rely on generic VR devices, which can limit the physical exertion in VR-based exercises. In contrast, physical props can enhance exercise intensity, yet their impact on users’ performance and experience remains ...
Zhenyu Liu +3 more
doaj +1 more source
Nickel‐based alloys are widely used in high‐temperature applications due to their excellent mechanical strength and oxidation resistance. However, properties such as high‐temperature strength and pronounced work‐hardening make them difficult to machine.
Soheil Rooein +2 more
wiley +1 more source
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Photoelectrochemical electrodes [PDF]
The surface of a moderate band gap semiconductor such as p-type molybdenum sulfide is modified to contain an adherent film of charge mediating ionene polymer containing an electroactive unit such as bipyridimium.
Rembaum, A., Williams, R. M.
core +1 more source
ZnS‐MXene‐TiO2 nanocomposite heterojunction for photocatalytic decomposition of this methylene blue dye (MB) greatly improves light absorption, charge separation, and active site area. Two‐dimensional MXene forms nanocomposites by easily combining them with 0D (quantum dots), 1D (tube and wire), 2D (plane and sheet), and 3D (particle and lamellar ...
Latiful Kabir +7 more
wiley +1 more source
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source

