Results 71 to 80 of about 639,615 (263)

Electrochemical Behavior of Flame‐Sprayed Sc‐Doped AlCoCrFeMo High‐Entropy Alloy Coatings in 3.5% Sodium Chloride Solution

Advanced Engineering Materials, EarlyView.
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar, Akash Vyas, Mohammad Aatif Qazi, Nashit Jalal, Maria Ophelia Jarligo, Mostafa Yakout, Jing Liu, André McDonald   +7 more
wiley   +1 more source

Triple Junctions as Dislocation‐Like Defects: The Role of Grain Boundary Crystallography Revealed by Experiment and Atomistic Simulation

Advanced Engineering Materials, EarlyView.
Grain boundary triple junctions are an essential ingredient of the microstructure of polycrystalline materials. In this study, a triple junction is observed using atomic‐resolution scanning transmission electron microscopy and characterized. Computer simulations reveal that the junction has a dislocation character that is determined by the joining ...
Tobias Brink, Saba Saood, Peter Schweizer, Jörg Neugebauer, Gerhard Dehm   +4 more
wiley   +1 more source

Modified Back Contact Interface of CZTSe Thin Film Solar Cells: Elimination of Double Layer Distribution in Absorber Layer

Advanced Science, 2018
Double layer distribution exists in Cu2SnZnSe4 (CZTSe) thin films prepared by selenizing the metallic precursors, which will degrade the back contact of Mo substrate to absorber layer and thus suppressing the performance of solar cell.
Zhaojing Zhang, Liyong Yao, Yi Zhang, Jianping Ao, Jinlian Bi, Shoushuai Gao, Qing Gao, Ming‐Jer Jeng, Guozhong Sun, Zhiqiang Zhou, Qing He, Yun Sun   +11 more
doaj   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

Active Corrosion Protection of Sintered AA7075 Aluminum Alloy via Mn Powder Addition

Advanced Engineering Materials, EarlyView.
AA7075 containing Mn‐rich particles is fabricated via spark plasma sintering using AA7075 and Mn powders. Corrosion resistance is evaluated through dip‐and‐dry tests using 0.1 M NaCl (pH 6.0), and mass loss decreases with increasing Mn addition. Mn‐rich particles function as a source of Mn ions, and formation of Mn‐accumulation films on Cu‐containing ...
Ko Ebina, Masashi Nishimoto, Izumi Muto
wiley   +1 more source

Reconstructed Polyamide Nanolayers via Two‐Stage Interfacial Polymerization Engineering for Precise Ion Sieving

Advanced Science
Efficient lithium extraction from brines remains challenging due to the comparable hydrated radii of Li+ and Mg2+ and the extreme ionic strength of the feed solutions. In this work, a reconstructed polyamide (PA) nanofiltration membrane was developed via
Shuzhen Zhao, Liheng Dai, Feidong Yang, Bowen Li, Pengfei Zhang, Yanyan Liu, Mengyang Hu, Kecheng Guan, Ryosuke Takagi, Hideto Matsuyama   +9 more
doaj   +1 more source

The Impact of Physical Props and Physics-Associated Visual Feedback on VR Archery Performance

Sensors
Most existing virtual reality exergames rely on generic VR devices, which can limit the physical exertion in VR-based exercises. In contrast, physical props can enhance exercise intensity, yet their impact on users’ performance and experience remains ...
Zhenyu Liu, Haojun Xu, Mengyang Tu, Feng Tian   +3 more
doaj   +1 more source

Influence of Scan Strategies in Electron Beam Powder Bed Fusion on Solidification, Microstructure, and High‐Temperature Compressive Properties of γ′‐Strengthened Inconel 738LC

Advanced Engineering Materials, EarlyView.
Experiments and thermophysical simulations were conducted to investigate the electron beam powder bed fusion electron beam (PBF‐EB/M) process for the γ′‐strengthened nickel‐based superalloy Inconel 738LC. The results demonstrate the impact of process‐induced microstructural variations on high‐temperature mechanical behavior, providing a basis for ...
Jan Niklas Petenati, Karthik Kumar Banku, Prasanth Bondi, Ivan Zhirnov, Yangyiwei Yang, Gordon Schmidt, Jürgen Christen, Georg Hasemann, Manja Krüger, Bai‐Xiang Xu, Bilal Gökce, Silja‐Katharina Rittinghaus   +11 more
wiley   +1 more source

Heterogeneity‐Guided Interlayer Tuning in Vermiculite‐MOF Membranes for Efficient Li+/Mg2+ Separation

Advanced Science
Precise separation of Li+/Mg2+ with similar ionic size remains a critical challenge for two‐dimensional (2D) membranes, largely due to the inherently tortuous and poorly regulated transport channels in the 2D interlayer.
Liheng Dai, Kecheng Guan, Mengyang Hu, Erda Deng, Pengfei Zhang, Zhan Li, Yongxuan Shi, Xiao Xu, Xueru Yan, Hideto Matsuyama   +9 more
doaj   +1 more source

Coordinating Drag-Based Structure Editing and Reference Style Transfer in Diffusion Models for Anime Images

Applied Sciences
Reference guided anime editing is challenging when the target requires both rendering style transfer and local structural change. Existing diffusion stylization methods that do not require training usually assume a fixed content layout, while drag-based ...
Youdong Ding, Wenjing Yu, Yafan Geng, Feifan Cai   +3 more
doaj   +1 more source