Results 101 to 110 of about 69,755 (267)
Power Characterisation for Fine-Grain Reconfigurable Fabrics
International Journal of Reconfigurable Computing, 2010 This paper proposes a benchmarking methodology for characterising the power consumption of the fine-grain fabric in reconfigurable architectures. This methodology is part of the GroundHog 2009 power benchmarking suite. It covers active and inactive power
Tobias Becker +4 more
doaj +1 more source
Low-Power Wireless Sensor Network Using Fine-Grain Control of Sensor Module Power Mode. [PDF]
Sensors (Basel), 2021 You S, Eshraghian JK, Iu HC, Cho K.
europepmc +1 more source
Impact of MgO Additions on the Oxidation Resistance and Compression Behavior of Vanadium Alloys
Advanced Engineering Materials, EarlyView.An increase in oxidation resistance at 600 °C is achieved for alloys containing more than 2.5 wt.% MgO. It has been established that, along with V2O5, MgO6V2, and Mg2O7V2 are formed, which are presumed to enhance oxidative stability. Furthermore, the possible transformation of Mg‐vanadates through reaction with CO2, which presumably occurs in this ...
Ievgen Solodkyi +5 more
wiley +1 more source
Data supporting the hierarchically activated deformation mechanisms to form ultra-fine grain microstructure in carbon containing FeMnCoCr twinning induced plasticity high entropy alloy. [PDF]
Data Brief, 2022 Rizi MS +5 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.The community‐driven Platform MaterialDigital Core Ontology (PMDco) 3.0 is introduced as a Basic Formal Ontology‐aligned semantic backbone for the processing–structure–properties paradigm in Materials Science and Engineering. Modular engineering, automated releases, and validation workflows are highlighted and key semantic patterns for materials ...
Markus Schilling +15 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.During creep of a single‐crystal Ni‐based superalloy, the overall crystal orientation is observed to remain constant while the microstructure evolves. Despite the lack of macroscopic rotation, small (<1°) rotations are observed on the submicron size scale and are accommodated by counteracting rotations over the scale of several micrometers.
E. J. Payton +3 more
wiley +1 more source
Metalurgija, 2019 Structural components which are loaded in cyclic load mostly fail due to fatigue. The fatigue strength of metals as well as weld joint regions in metals depends on mechanical properties especially hardness, the size of defect and the size of grains ...
F. Smaili, T. Vuherer, I. Samardžić
doaj
Mechanism of interfacial microstructure evolution of G115 steel in simulated heat affected zone
Cailiao gongchengThe microstructure evolution of the interface in the simulated heat affected zone （HAZ） of G115 steel was characterized by electron backscatter diffraction （EBSD） and high resolution transmission electron microscopy （HRTEM）.
JIANG Jundong +5 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Schematic representation of modes of microcrack nucleation, growth and temporary arrestment at different boundaries, with the criteria for crack propagation in three scenarios: (1) large notch, (2) defect/small sharp notch, and (3) long crack. This work revisits and integrates results on the fatigue behavior of advanced bainitic steels (in particular ...
Lucia Morales‐Rivas
wiley +1 more source