Results 111 to 120 of about 81,916 (317)
Biomechanical Investigation of Bone Screw Head Design for Extracting Stripped Screw Heads: Integration of Mechanical Tests and Finite Element Analyses. [PDF]
Materials (Basel), 2023 Khalaf K, Azhang A, Cheng CH, Nikkhoo M.
europepmc +1 more source
Design analysis of ductile failure in dovetail connections
, 2008 The static plastic collapse of ductile dovetail structures is investigated by three analysis methods: slip-line field (SLF) theory based on a sheet drawing model, finite element limit analysis, and linear elastic finite element analysis with adapted ...
Naruse, T., Mackenzie, D.
core +1 more source
Advanced Engineering Materials, EarlyView.This work studies the anisotropic behavior of circular notched tensile specimens of Ni‐base superalloy single crystals during high‐temperature tensile creep along [001], [110], and [111]. Correlative scale‐bridging imaging of specimens reveals early rupture along [110] because 1) plastic deformation proceeds faster at notch center; 2) more (brittle ...
Leonardo Agudo Jácome +6 more
wiley +1 more source
MATEC Web of Conferences, 2014 Statistical analysis reveals that mechanical damage is the first cause of incidents on gas transmission pipelines. They can be created by third party activities such as excavator tooth impact or by interaction between the pipe and rocks.
Burgaud Guillaume +5 more
doaj +1 more source
Finite element analyses of lateral condyle fracture fixation in paediatrics regarding configuration of Kirschner-wire. [PDF]
BMC Musculoskelet Disord, 2022 Jeon S +5 more
europepmc +1 more source
FINITE ELEMENT ANALYSES OF SUPERADOBE DOMES
, 2019 This article shows Static structural analyses performed on 35 different Superadobe domed models. The dimensions of these models were defined according to a controlled variation of initial parameters, guided by previously derived equations. Maximum and Minimum principal stresses, Shear stresses and total deformations were measured assuming an idealized ...
openaire +3 more sources
Advanced Engineering Materials, EarlyView.X‐ray computed tomography reveals how process‐induced defects evolve from green to sintered states in Fused Filament Fabrication (FFF)‐manufactured 17‐4PH stainless steel. Internal porosity, weakest cross‐sections, and fracture locations show strong correlation with tensile performance, demonstrating the potential of computed tomography (CT)‐based ...
György Ledniczky +3 more
wiley +1 more source
Atlas-based finite element analyses with simpler constitutive models predict personalized progression of knee osteoarthritis: data from the osteoarthritis initiative. [PDF]
Sci Rep, 2023 Mononen ME +3 more
europepmc +1 more source
The numerical modelling of rockbolts in geomechanics by finite element methods
, 1998 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University, 15/03/1999.In tunnel excavation, the use of rockbolts has long been a popular means of reinforcement in rock masses to prevent the rock opening from caving
Chao, Tung-Yo, Chao, T.
core
Design and Analysis of Compression–Torsion Coupling Metamaterials Using the Golden Section Method
Advanced Engineering Materials, EarlyView.A novel compression–torsion metamaterial is engineered using inclined rods and symmetry breaking. To optimize its torsional performance, the golden section method is employed. The mechanical response of the metamaterial is validated through both numerical analysis and experimental validation.
Amirhossein Hassani, Sara Bagherifard
wiley +1 more source