Results 11 to 20 of about 5,351 (163)
FIR Filter Sharpening by Frequency Masking and Pipelining-Interleaving Technique
This paper focuses on the improvements of digital filters with a highly sharp transition zone on the Xilinx FPGA chips by combining a sharpening method based on the amplitude change function and frequency masking and PI (Pipelining-Interleaving ...
CIRIC, M. P. +3 more
doaj +1 more source
Studying Consistency of Some Flitters Using Simulation [PDF]
This paper includes a simulation study of three well-known filters in real lift application. These filters are - filter, Kalman filter and FIR filter.
doaj +1 more source
Design of Low-Power Multiplierless Linear-Phase FIR Filters
In the design of multiplierless finite impulse response (FIR) filters, tremendous efforts have been made to reduce the number of adders of the multiplier block for the reduction of overall chip area and power consumption. However, fewer in the multiplier
Wen Bin Ye, Xin Lou, Ya Jun Yu
doaj +1 more source
Minimum BER Receiver Filters with Block Memory for Uplink DS-CDMA Systems
The problem of synchronous multiuser receiver design in the case of direct-sequence single-antenna code division multiple access (DS-CDMA) uplink networks is studied over frequency selective fading channels.
Mérouane Debbah +1 more
doaj +2 more sources
Noniterative Design of 2-Channel FIR Orthogonal Filters
This paper addresses the problem of obtaining an explicit expression of all real FIR paraunitary filters. In this work, we present a general parameterization of 2-channel FIR orthogonal filters.
M. Elena Domínguez Jiménez
doaj +2 more sources
Analysis and Simulation of Reduced FIR Filters [PDF]
High order FIR filters employ model reduction techniques, in order to decrease power consumption and time delay. During reduction high order FIR filters are converted into low order IIR filters preserving stability and phase linearity as main features ...
Lj. Radic, W. Mathis
doaj
LOW COST APPROXIMATE ADDER SUBTRACTOR FOR FIR FILTER
The cost of the FIR filter depends on the cost of its components that are classified into three types namely buffer, multiplier and adder/subtractor.The adder/subtractor cover the most FIF.
W.A. Mahmou +2 more
doaj +1 more source
Method for optimization of FIR filter characteristics using the whale optimization algorithm
The article discusses the analysis of the whale optimization algorithm with the aim of applying it to optimize the coefficients of digital filters with linear phase.
R.V. Petrosian, A.R. Petrosian
doaj +1 more source
Two-Dimensional FIR Filters [PDF]
Chapter ...
Ansari, R., Çetin, A. Enis
openaire +2 more sources

