Results 21 to 30 of about 51,959 (304)
Fuzzy Based Sliding Mode Control of Vector Controlled Multiphase Induction Motor Drive under Load Fluctuation [PDF]
Journal of Electrical and Electronics Engineering, 2022 This paper describes a sliding mode-based fuzzy logical method with a PID controller that was used to control the speed of an indirect filed oriented vector control (IFOC) multiphase induction motor drive.
YESGAT Amare Worku +2 more
doaj
Analysis and design of a two-speed single-phase induction motor with 2 and 18 pole special windings [PDF]
, 2005 The motor presented employs multiple independent windings for operation with two very different pole numbers. The 18-pole field is produced with a symmetrical three-phase winding connected in a Steinmetz arrangement to a single-phase supply.
Dellinger, S.J. +4 more
core +1 more source
IEEE Access, 2019 Multiphase machines have attracted significant attention in both academic and industrial sectors as candidates for high-power safety-critical applications as well as wind energy conversion systems.
Ayman S. Abdel-Khalik +2 more
doaj +1 more source
Nonlinear Optimal Control for a Gas Compressor Actuated by a Five-Phase Induction Motor
Power Electronics and Drives, 2023 The article proposes a nonlinear optimal control method for the dynamic model of a gas centrifugal compressor being actuated by a five-phase induction motor (5-phase IM).
Rigatos G. +3 more
doaj +1 more source
IEEE Open Journal of the Industrial Electronics Society, 2021 This paper proposes a sensorless field-oriented control (FOC) of an open-end stator winding five-phase induction motor (OESW-FPIM). The FOC technique used is associated with dual Space Vector Modulation (SVM) to provide a constant switching frequency and
Saad Khadar +2 more
doaj +1 more source
Line-start permanent-magnet motor: single-phase starting performance analysis [PDF]
, 2002 This paper presents a detailed quasi-steady-state approach to different torque components (average and pulsating) for a single-phase capacitor-run permanent-magnet (PM) motor.
McGilp, M.I. +11 more
core +1 more source
Field-oriented control of five-phase induction motor with open-end stator winding
Archives of Electrical Engineering, 2016 The mathematical model of the five-phase squirrel-cage induction motor and the system of the dual five-phase voltage source inverter have been presented.
Listwan Jacek, Pieńkowski Krzysztof
doaj +1 more source
IEEE Access, 2022 This paper presents the field-oriented control (FOC) of a five-phase induction motor (FPIM) fed from a three-to-five phase direct matrix converter (DMC).
Khaliqur Rahman +6 more
doaj +1 more source
Computation of Optimal Current References for Flux-weakening of Multi-Phase Synchronous Machines [PDF]
, 2012 Multi-phase synchronous machines are more and more used in specific applications where high power density, low bus voltage, wide speed range and fault-tolerant capabilities are required. Due to the high number of degrees of freedom, multi-phase machines
Bassel Aslan +13 more
core +1 more source
Five-phase version of 12slots/8poles three-phase Synchronous Machine for Marine-propulsion [PDF]
, 2014 Multiphase machines are widely used in electric marine propulsion especially because of their fault-tolerance which allows to guarantee the propulsion even if a fault occurs in the electrical system.
SCUILLER, Franck +5 more
core +1 more source