Results 141 to 150 of about 4,011,958 (262)

A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation

open access: yesAdvanced Engineering Materials, EarlyView.
A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler   +4 more
wiley   +1 more source

Low carbon concrete sidewalk pilot

open access: yes, 2020
This case study provides information on the City of Portland's first round of low-carbon concrete pilot projects, featuring sidewalk ramps within the City's Bureau of Transportationdeveloped by members of the Carbon Leadership Forum Hub in Portland ...

core  

Enhancement of the Through‐Thickness Electrical Conductivity of Carbon‐Fiber‐Reinforced Plastics Using Large Graphite Particles

open access: yesAdvanced Engineering Materials, EarlyView.
To enhance through‐thickness conductivity without sacrificing impregnation, large spherical graphite particles are intentionally employed in a low‐viscosity resin. Unlike finer conductive fillers, these particles remain outside the fiber bundles and accumulate in resin‐rich interlaminar regions during molding.
Keito Hosoe   +6 more
wiley   +1 more source

3D‐Printed Titanium Gyroid Scaffold Structure Integrated With Tough Hybrid Materials for Cartilage Replacement

open access: yesAdvanced Engineering Materials, EarlyView.
This study proposes a potential device design for joint cartilage replacement. Silica‐polytetrahydrofuran (SiO2‐PolyTHF) hybrids with customizable mechanical properties were developed to mimic the characteristics of a natural meniscus. These were synthesized through a two‐pot sol–gel hybrid process.
Yu‐Chien Lin   +12 more
wiley   +1 more source

Scarcity of fixed carbon transfer in a model microbial phototroph-heterotroph interaction. [PDF]

open access: yesISME J
Dupuis S   +7 more
europepmc   +1 more source

The Role of Ultra‐Thin Passive Films and Organic Adsorbates on Aluminum Chips for a Friction‐Induced Solid‐State Recycling Process

open access: yesAdvanced Engineering Materials, EarlyView.
Despite benefits to storage stability and handleability of aluminum scrap, octadecyl phosphonic acid (ODPA) SAMs reduce the tensile strength of wires produced using friction‐induced recycling. Etching and methyl diphosphonic acid (MDPA) coatings, however, have little effect.
Timothy D. Goller   +3 more
wiley   +1 more source

Temporary carbon storage and discount rates [PDF]

open access: yes
Several approaches have been proposed for accounting for temporary carbon sequestration in land-use change and forestry projects that are implemented to offset permanent emissions of carbon dioxide from the energy sector.
Menz, Kenneth M.   +2 more
core  

Impact of the Process Atmosphere During Hot Isostatic Pressing on the Near‐Surface Composition of an Additively Manufactured Austenitic High‐Interstitial Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A high interstital austenitic steel is additively manufactured and postdensified by HIP to eliminate gas porosity. Thereby, the loss of N and Mn in Ar HIP atmosphere is investigated. Further, HIP using N2 atmosphere is investigated which led to excessive nitride formation.
F. Großwendt   +4 more
wiley   +1 more source

The mobilization and transport of newly fixed carbon are driven by plant water use in an experimental rainforest under drought. [PDF]

open access: yesJ Exp Bot
Huang J   +23 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy