Results 91 to 100 of about 120,965 (295)
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Low-Cost Biaxial Skin Sensors for Large Strain Measurement [PDF]
, 2019 Undergraduate ...
Donica, Thomas, Gray, Jonathan
core +1 more source
A Workflow to Accelerate Microstructure‐Sensitive Fatigue Life Predictions
Advanced Engineering Materials, EarlyView.This study introduces a workflow to accelerate predictions of microstructure‐sensitive fatigue life. Results from frameworks with varying levels of simplification are benchmarked against published reference results. The analysis reveals a trade‐off between accuracy and model complexity, offering researchers a practical guide for selecting the optimal ...
Luca Loiodice +2 more
wiley +1 more source
Elinvar Materials: Recent Progress and Challenges
Advanced Engineering Materials, EarlyView.Elinvar materials, exhibiting temperature‐invariant elastic modulus, are critical for precision instruments and emerging technologies. This article reviews recent progress in the field, with a focus on the anomalous thermoelastic behavior observed in key material systems.
Wenjie Li, Yang Ren
wiley +1 more source
FE tool for drape modelling and resin pocket prediction of fully embedded optical fiber sensor system [PDF]
, 2015 This work highlights some of the achievements obtained within the EU FP7 SmartFiber project, aiming to develop a fully embeddable optical fiber sensor system including the interrogator chip.
Ahmed, Tahira +9 more
core +2 more sources
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Construction monitoring constraints and challenges:A feasibility study [PDF]
, 2013 This paper presents a study of the constraints and challenges faced by the authors when invited to study the feasibility of developing a monitoring system to provide specific information sought by the designer and contractor during the construction of ...
Fidler, Paul +5 more
core +2 more sources
Advanced Engineering Materials, EarlyView.A numerical–experimental framework is developed for characterizing multi‐matrix fiber‐reinforced polymers (MM‐FRPs) combining epoxy and polyurethane matrices. Harmonic bending tests are integrated with finite element model updating (FEMU) to simultaneously identify elastic and viscoelastic material parameters.
Rodrigo M. Dartora +4 more
wiley +1 more source
Piezoceramics-based Devices for Active Balancing of Flexible Shafts [PDF]
, 2006 This paper focuses on vibration control of flexible shafts by means of rotorfixed piezoelectric materials. The target is to realize compact solutions for the suppression of problematic resonant vibration at so-called flexural critical speeds.
Boer, A. de, Sloetjes, P.J.
core +1 more source
Study of a Flexible UAV Proprotor [PDF]
, 2013 This paper is concerned with the evaluation of design techniques, both for the propulsive performance and for the structural behavior of a composite flexible proprotor.
Bénard, Emmanuel +5 more
core +2 more sources