Results 51 to 60 of about 74,287 (313)

Experimental Investigation and Numerical Modeling of Two-Phase Flow Development and Flow-Induced Vibration of a Multi-Plane Subsea Jumper

Journal of Marine Science and Engineering, 2022
As an essential component in the offshore oil and gas industry, subsea jumpers are likely to encounter the cyclic-induced stresses caused by the alternating movement of gas plugs and liquid slugs while transporting a multiphase mixture. The present study
Wenhua Li, Qing Zhou, Guang Yin, Muk Chen Ong, Gen Li, Fenghui Han   +5 more
doaj   +1 more source

Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics

Advanced Engineering Materials, EarlyView.
Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost, Lionel Presmanes, Soléna Colin, Marie Vidal, Sophie Guillemet‐Fritsch   +4 more
wiley   +1 more source

Modelling of coupled cross-flow/in-line vortex-induced vibrations using double Duffing and van der Pol oscillators

, 2012
Many studies have typically applied a linear structural spring–mass–damper oscillator and a van der Pol wake oscillator to model a one-dimensional cross-flow vortex-induced vibration (VIV).
Zanganeh, Hossein, Srinil, Narakorn
core   +1 more source

Cavity induced vibration of flexible hydrofoils [PDF]

, 2014
The objective of this work is to investigate the influence of cavity-induced vibrations on the dynamic response and stability of a NACA66 hydrofoil at 8° angle of attack at Re=750 000 via combined experimental measurements and numerical simulations.
CHAE, Eun Jung, AKCABAY, Deniz Tolga, YOUNG, Yin Lu, DUCOIN, Antoine, ASTOLFI, Jacques Andre   +4 more
core   +1 more source

Fostering Innovation: Streamlining Magnetocaloric Materials Research by Digitalization

Advanced Engineering Materials, EarlyView.
Magnetocaloric cooling (MCE) is an environmentally friendly refrigeration method with great potential. Optimizing MCE materials involves the preparation and screening of large quantities of samples, which in turn generates a large amount of data. A digitalization approach is presented that uses ontologies, knowledge graphs, and digital workflows to ...
Simon Bekemeier, Moritz Blum, Luana Caron, Alisa Chirkova, Philipp Cimiano, Basil Ell, Inga Ennen, Michael Feige, Maik Gaerner, Thomas Hilbig, Andreas Hütten, Günter Reiss, Tapas Samanta, Sonja Schöning, Christian Schröder, Lennart Schwan, Chris Taake, Martin Wortmann   +17 more
wiley   +1 more source

Effects of Damping and Reynolds Number on Vortex-Induced Vibrations [PDF]

, 2007
Vortex-induced vibrations have been studied experimentally with emphasis on damping and Reynolds number effects. Our system was an elastically-mounted rigid circular cylinder, free to oscillate only transverse to the flow direction, with very low ...
Klamo, Joseph Thomas
core   +1 more source

Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy

Advanced Engineering Materials, EarlyView.
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang, Aparajita Pramanik, Sandipan Sen, Shubhashis Dixit, Marcel Muench, R. J. Vikram, Daniel Schliephake, Yolita M. Eggeler, Ankur Chauhan, Martin Heilmaier, Alexander Kauffmann   +10 more
wiley   +1 more source

Distributed lock-in drives broadband vortex-induced vibrations of a long flexible cylinder in shear flow [PDF]

, 2013
A slender flexible body immersed in sheared cross-flow may exhibit vortex-induced vibrations (VIVs) involving a wide range of excited frequencies and structural wavenumbers.
Triantafyllou, Michael S., Karniadakis, George E., Bourguet, Rémi   +2 more
core   +1 more source

Influence of Cross-Sectional Configuration on the Longitudinal Vortex Excitation of the Upstream Cylinder in Cruciform Two-Cylinder System

Journal of Fluid Science and Technology, 2006
In earlier works by the present authors, it was shown that a large cross-flow excitation is induced to a circular cylinder by setting another cylinder downstream in a cruciform arrangement with a certain gap between them, caused by longitudinal vortices ...
Naoto KATO, Mizuyasu KOIDE, Tsutomu TAKAHASHI, Masataka SHIRAKASHI   +3 more
doaj   +1 more source

Current Status and Challenges in Data Collection for Aerospace Coatings Deposited by Plasma Spraying

Advanced Engineering Materials, EarlyView.
An innovative approach has been integrated into the GRENAT project to optimize plasma spraying and coating performance. Raw materials are accelerated and melted in the plasma generated by torches, creating coatings. Monitoring sensors collect process data which are combined with ex situ characterization data.
Lila Randriamananjara, Vincent Rat, Quentin Dubreuil, Patrice Valorge, Simon Goutier, Alain Denoirjean, Olivier Messe, Céline Ruelle, Jean‐Philippe Poli   +8 more
wiley   +1 more source