Results 211 to 220 of about 3,382 (273)
Energy Procedia, 2014 The effects of coal rank, coal composition, and pressure on the CO 2 adsorption capacity of five South African coal samples were evaluated. Adsorption isotherms of the flue gases on coal were measured at 35 °C and up to a maximum pressure of 88 bar using
Kasturie Premlall
exaly +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
, 2020
This study investigated the influence of feed gas composition on structural transformation and guest exchange behaviors in the replacement of sH (CH4 + methylcyclopentane) hydrate with CO2 + N2 for energy recovery and CO2 sequestration. CO2 + N2 mixtures
Wonjung Choi +3 more
semanticscholar +1 more source
This study investigated the influence of feed gas composition on structural transformation and guest exchange behaviors in the replacement of sH (CH4 + methylcyclopentane) hydrate with CO2 + N2 for energy recovery and CO2 sequestration. CO2 + N2 mixtures
Wonjung Choi +3 more
semanticscholar +1 more source
Experimental investigation of the flue gas thermochemical composition of an oxy-fuel swirl burner
Fuel, 2018The level of understanding of coal combustion compared to the requirements of predictive engineering is still insufficient due to the complexity of the processes and breadth of scales involved.
S. Bürkle +3 more
semanticscholar +1 more source
Direct Electrochemical Conversion of CO2 from Industrial Flue Gases.
ChemSusChemElectrochemical CO2 conversion to high-value chemicals and fuels has been extensively investigated as a promising carbon-neutrality technology. To date, most studies are generally performed with pure or highly concentrated CO2 feeds, however the ...
Xiaojuan Wen, Dunfeng Gao, Guoxiong Wang
semanticscholar +1 more source
Modeling of Ammonia MILD Combustion in Systems with Internal Recirculation
Combustion Science and Technology, 2023The present work focuses on the combustion of alternative renewable fuels, ammonia in this case, in a system, such as the Laboratory Unit CYclonic (LUCY) burner.
L. Giuntini +5 more
semanticscholar +1 more source
International journal of hydrogen energy, 2019
An experimental investigation of methane reforming with flue gases obtained by combustion of methane with the ratio of air to methane of 1 is carried out over NiO-Al2O3 catalyst.
D. Pashchenko
semanticscholar +1 more source
An experimental investigation of methane reforming with flue gases obtained by combustion of methane with the ratio of air to methane of 1 is carried out over NiO-Al2O3 catalyst.
D. Pashchenko
semanticscholar +1 more source
Proceedings of the Combustion Institute, 2013
Abstract A 37 kW down fired pilot scale laboratory combustor, specially modified to allow recycle of both dirty and cleaned flue gas, was used to investigate aerosol formation under air- and oxy-coal combustion conditions. The focus was on emission of soot or black carbon, formation of fine and ultra-fine particulate matter, and partitioning and ...
William J. Morris +2 more
openaire +1 more source
Abstract A 37 kW down fired pilot scale laboratory combustor, specially modified to allow recycle of both dirty and cleaned flue gas, was used to investigate aerosol formation under air- and oxy-coal combustion conditions. The focus was on emission of soot or black carbon, formation of fine and ultra-fine particulate matter, and partitioning and ...
William J. Morris +2 more
openaire +1 more source
International Journal of Coal Geology, 2017
Abstract This study investigated the multipollutant control effectiveness for Hg 0 /SO 2 /NO using V, Mn, and Cu oxides/mesoporous SiO 2 particulate composites. The presence of metal oxides decreased the specific surface area and pore volume and altered the surface morphology and sizes of the raw SiO 2 particles.
Chun-Hsiang Chiu +5 more
openaire +1 more source
Abstract This study investigated the multipollutant control effectiveness for Hg 0 /SO 2 /NO using V, Mn, and Cu oxides/mesoporous SiO 2 particulate composites. The presence of metal oxides decreased the specific surface area and pore volume and altered the surface morphology and sizes of the raw SiO 2 particles.
Chun-Hsiang Chiu +5 more
openaire +1 more source
Journal of Environmental Management, 2021
Oil-based drilling cuttings (OBDC) produced from shale gas development is a hazardous waste that have high calorific values and should be disposed of properly.
Tingting Liu +7 more
semanticscholar +1 more source
Oil-based drilling cuttings (OBDC) produced from shale gas development is a hazardous waste that have high calorific values and should be disposed of properly.
Tingting Liu +7 more
semanticscholar +1 more source