Results 41 to 50 of about 428 (171)
The development of novel proton-conducting membrane materials for electrochemical power units, i.e., low temperature fuel cells (FCs), efficiently working up to 300 °C, is a critical problem related to the rapid shift to hydrogen energy.
Olga Yu. Kurapova +5 more
doaj +1 more source
Enhancing Mucus Flow and Clearance by Grafting Zwitterionic Hydrogel Films to Luminal Surfaces
Zwitterionic hydrogel films on typical medical materials reduce resistance to mucus flow, increase mucus discharge, and may facilitate faster clearance of dried mucus. These effects are most pronounced on tubes of larger diameter. ABSTRACT Objective To determine the effects of zwitterionic hydrogel films on mucus contact angles, flow, and stasis with ...
Ryan Horne +4 more
wiley +1 more source
MECHANOMAGNETIC REACTOR FOR ACTIVATION OF ANTICANCER DRUGS [PDF]
Mechanomagnetochemical activation can increase the concentration of paramagnetic centers (free radicals) in the anticancer drug, for example, doxorubicin that enables to influence its magnetic properties under external electromagnetic field and improve ...
Orel V. E. +6 more
doaj +1 more source
The feasibility of endoscopic stapes surgery: A three‐dimensional planning method
The accuracy of a semi‐automatic algorithm in assessing the feasibility and complexity of endoscopic stapes surgery preoperatively was investigated. A preoperative planning model can assist ENT surgeons and improve their confidence. Abstract Objective The primary aim of this study was to investigate the accuracy of a semi‐automatic algorithm in ...
Maaike Jellema +7 more
wiley +1 more source
Geometrical distortions during the transfer process limit the adhesion strength of gecko‐inspired adhesives on curved surfaces, especially undevelopable surfaces. A method capable of growing mushroom‐shaped adhesion structures in situ on surfaces with different curvatures is realized by applying a modulated electric field.
Hongmiao Tian +9 more
wiley +1 more source
ELASTO-PLASTIC BENDING OF A FLUOROPLASTIC TAPE AT BENDING IN A RING
A technological process of production of sealing fluoroplastic rings from a band workpiece is considered and the possibility of their production by a method of cold coiling of the tape on a cylindrical mandrel is investigated; the helix is cut in rings ...
G. A. Vershina, L. E. Reut
doaj
Abstract Possible discontinuities in the subsurface have a major impact on the load‐bearing behavior of post‐installed fastenings. For concrete, the behavior of post‐installed anchors and thus their design can be clearly addressed as concrete is assumed as a homogeneous fastening substrate.
O. Zeman +2 more
wiley +1 more source
Analytical method for determining the temperature dependence of the thermal conductivity coefficient
The paper developed an analytical method for determining the temperature dependence of the thermal conductivity coefficient, which is based on the approximation of the temperature field obtained using an infrared thermal imaging camera by the solution of
Ya.P. Saliy, B.S. Dzundza
doaj +1 more source
We built a dense and conformal LiF modification layer on the LiCoO2 surface by pyrolysis of a lithiated polyvinylidene fluoride coating under an air atmosphere. The as‐obtained LiF layer can effectively suppress the interfacial side reactions and surface structure degradation, and thereby greatly enhance the high‐voltage cycling stability of the LiCoO2
Qihang Ding +6 more
wiley +1 more source
The development of innovative proton-conducting materials for low-temperature fuel cells (FCs) is, today, a central topic among the scientific community.
Sofia Mendes, Pedro Faia
doaj +1 more source

