Results 81 to 90 of about 349 (177)

Study on cohesion and adhesion behaviors of the zeolite foamed asphalt-warm mix mixture based on molecular dynamics simulation

Case Studies in Construction Materials
Zeolite foamed asphalt - warm mix mixture (ZFA-WMM) has been applied in large quantities in asphalt pavement, however, a lower construction temperature, residual zeolite water and zeolite minerals have different effects on the cohesion and adhesion ...
Ning Liu, Liping Liu, Zhitao Zhang, Mingchen Li, Lijun Sun   +4 more
doaj   +1 more source

Optimizing Foamed Bitumen Mixtures: AI-Based Determination of Ideal RAP and FBC Percentages Using HWTT and ITS Data

Applied Sciences
The combination of reclaimed asphalt pavement (RAP) and foamed bitumen content (FBC) in bitumen mixtures presents a viable and economically advantageous approach to asphalt pavement construction. This investigation delves into the optimal combinations of
Ali Saleh, László Gáspár
doaj   +1 more source

Impacts of Milled Aggregate Gradations and Foamed Asphalt Contents of Cold In-Place Recycling Layer on the Performance of Asphalt Overlays

Infrastructures
This paper presents gradations of both Hot In-place Recycling (HIR) and Cold In-place Recycling (CIR) and analysis of cores collected from CIR/Hot Mix Asphalt (HMA) overlay sections in Iowa.
Hosin Lee, Byungkyu Moon, Ashley Buss, Charles T. Jahren   +3 more
doaj   +1 more source

Influence of Waste Engine Oil Addition on the Properties of Zeolite-Foamed Asphalt. [PDF]

Materials (Basel), 2019
Woszuk A, Wróbel M, Franus W.
europepmc   +1 more source

Use of Foamed Asphalt and Foamed Bitumen for Recycled Asphalt Mixtures: A Review

Civil Engineering and Architecture
Luis Villegas, Noe Marín, Cesar Idrogo, Robert Suclupe, Atilio López, Guillermo Arriola   +5 more
openaire   +1 more source

Influence of foaming water content and mixing temperature on foam asphalt mixtures

, 2021
High air void content and inadequate coating of coarse aggregate particles are major challenges in the application of warm mix asphalt (WMA) using foam asphalt technology. Aggregate particle coating has significant influence on air voids content in foam asphalt mixture and is directly dependent on the volume of foam bitumen in the mixture and ...
openaire   +1 more source

Introduction of recycled polyurethane foam in mastic asphalt

Građevinar, 2018
The aim of this paper is to analyse the suitability of recycled polyurethane (PU) foam as a binder modifier in mastic asphalts (MA). The results show that harder bitumen is achieved with an increasing percentage of PU, up to 5 %, when the workability of the sample becomes poor. A MA mix with a 4 % of PU in bitumen was manufactured.
Miguel Ángel Salas, Heriberto Pérez-Acebo   +1 more
openaire   +2 more sources

The Effect of Hydrated Lime on the Low-Temperature Properties of Foamed Asphalt Mixture (FAM). [PDF]

Materials (Basel)
Iwański MM, Cholewińska M, Podsiadło M.   +2 more
europepmc   +1 more source

Multi-Parameter Collaborative Optimization of Foamed Asphalt Cold Recycling Mixture Properties. [PDF]

Materials (Basel)
Qiu W, Li B, Song Z, Zou X, Hu M, Bi Y.
europepmc   +1 more source

Effect of Steel Slag and Air-Cooled Blast Furnace Slag Aggregates on the Performance of Warm-Mix Asphalt Concrete Produced with Foamed Bitumen. [PDF]

Materials (Basel)
Stępień J, Maciejewski K, Ramiączek P, Chomicz-Kowalska A.   +3 more
europepmc   +1 more source